A) Lynx Router Of General Entrance; B) Lynx Router Of Block; C) Lynx Router Of Apartment; Wan Setup - Fermax LYNX Manual De Instalador

L L L L L YNX R YNX R YNX R YNX ROUTER OUTER OUTER OUTER
YNX R OUTER
L L L L L YNX R YNX R YNX R OUTER OUTER
YNX R YNX ROUTER OUTER OUTER

a) Lynx Router of General Entrance

In this case, there is only one Lynx Router for the full installation.
The IP address will be assigned by default to 10.206.0.0

b) Lynx Router of Block

In this case, the Lynx Router provides service to all the units in a block.
The installer must select the block number where he has installed it. The system allows
up to 100 blocks.
This Lynx Router is assigned automatically to all of the units in that block.
The IP address will be calculated in function of the block number.

c) Lynx Router of Apartment

In this case, the Lynx Router provides service to an individual apartment.
The installer must select:
- Block Number: The block number where the apartment belongs.
- Router Lynx Number : Only 511 apartments per block can be configured, so the system
does not allows selecting the apartment number. Instead, a sequential number must be
selected by the installer. In case the block, Device number combination already exists, the
system shows a warning and does not allow it.
The IP address is calculated in function of the block number and the Lynx Router number.

- WAN setup

Depending on the configuration of the Internet router, the WAN IP is configured
automatically (DHCP) or you must set all network parameters.
Pag 7