HTC Mobile Clamp Rack Manual Del Operador página 4

5. Line up the holes of your completed Flat Cross Support to the holes
in the Floor Braces and insert the stem of (2) Locking Swivel Wheels
through the bottom of the completed Main Frame and insert the stem
of (2) Standard Swivel Wheels through the bottom of the Rear Frame.
Tighten the swivel wheels in place using the (4) Large Nuts (M10)
(4) Large Washers (ø10)
6. Carefully stand the Clamp Rack upright (Figure 7) and lock the Swivel
Wheels.
7. Insert (1) Long Round Rod
Insert second long Round Rod into the fourth hole from bottom (Figure
8). Secure both long round rods in place with Latch Pins
8. The remaining Short Round Rods
positions and secured with hairpin clips
9. Install the Oversize Clamp Angle
the rack, by aligning the holes in the Top Brace
with the holes in your Oversize Clamp Angle
(2) Small Hex Bolts (M6x12)
Small Washers (ø6)
10. The HTC Mobile Clamp Rack is now ready to use.
.
into the bottom hole of the Main Frame.
can be inserted into their preferred
.
, with the slots facing the front of
, (2) Small "Nyloc" Nuts (M6)
.
Figure 7
Figure 8
and
.
of your Main Frame
(Figure 9). Secure with
, and (2)
4
Figure 4
Figure 5
Figure 6
Figure 9