Installing The In-Room Emergency Pushbutton Unit; Operation And Maintenance - Pego ECPAPE03 Manual De Uso

CHAP. 2 - Installation
2.2
1. The in-room pushbutton must be positioned so that it is always visible and easily
reachable.
2. Undo the four closure screws on the front of the pushbutton panel.
3. Using the four internal holes fix the box backing with four screws of a length suitable for
the thickness of the wall to which it is to be attached.
2.3
- Carry out the connections as per the wiring diagram.
- After initial connection it will take 110 hours to fully charge the battery.
- Press the luminous pushbutton installed inside the cold room to activate the
acoustic and luminous warning devices on the external alarm control unit. The
auxiliary relay contact closes.
In the event of a 230 V AC power failure the buffer battery will intervene and power
-
the system for the duration indicated on the technical characteristics chart.
Reset the emergency switch inside the cold room to cancel the alarm.
-
Periodically check that the buffer battery is working properly.
-
If the battery is replaced make sure it is disposed of properly at an authorised waste
-
collection facility.
If the alarm is tripped without the pushbutton being pressed check the connection
-
lead and the connections between the pushbutton and external control unit.
SPARE PARTS:
Buffer battery: 100APEBATT
Rev.01-18
INSTALLING THE IN-ROOM EMERGENCY PUSHBUTTON

OPERATION AND MAINTENANCE

USE AND MAINTENANCE MANUAL
ECPAPE03
- ENG -
Pag. 17