Installing The Out-Of-Room Alarm Control Unit - Pego ECPAPE03 Manual De Uso

ECPAPE03
+
CHAPTER 2: INSTALLATION

INSTALLING THE OUT-OF-ROOM ALARM CONTROL UNIT

1.
Undo the 4 closure screws on the front panel.
2.
Use the three existing holes to fix the box back panel to
the wall: use three screws of a length suitable for the
thickness of the wall to which the panel will be attached. Fit a
rubber washer (supplied) between each screw and the box
backing.
Make all the electrical connections as illustrated in the diagram for the corresponding model (see
relative table in APPENDICES). To effect correct electrical connection and maintain the protection
rating, use appropriate wire/raceway grips to ensure a good seal. Route the wiring inside the unit in
as tidy a fashion as possible: be especially careful to keep power wires away from signal wires.
Use clips to hold wires in place.
3.
Re-close the front panel, making sure that all the wires are inside
the box and that the box seal sits in its seat properly.
Tighten the front panel using the 4 screws, making sure the O-rings
on the head of each screw are used.
USE AND MAINTENANCE MANUAL
Pag. 16
- ENG -
CHAP. 2 - Installation
Rev.02-17
2.1