Care; Brush Assembly - Sears Kenmore 11659512992 Manual Del Proprietário

5. Carefully
insert and
twist
screwdriver
at each
brush
support to
free brush
from base.
Brush
Support II
k
t4
6. Remove worn
belt,
7. Slide brush
supports off to
check and clean
brush support
areas. See
BRUSH
ASSEMBD( for
picture of
complete brush
assembly.
TO REPLACE BELT:
1. Slide washers and brush supports onto
brush assembly_
2, Install
new belt
over motor
drive, then
over brush
sprocket,
NOTE: See
PARTS AND
for Belt #o
1
Brush
Support
__ Motor
_ush Drive
Brush Sprocket
3. Snap brush
supports into
place on base.
Be sure brush
supports are
not upside-
down,
4. Line up
front of cover
and base,
Rest cover
on front edge -....
of base as
shown.
Cover Base
5. Tilt cover to
back. Press
cover firmly until
side tabs snap
into place.
Replace cover
screws, light
bulb and light
cover.
15