Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CONNECT
VENT
1.
Using a 4" (10.2 cm) clamp,
connect
vent to exhaust outlet
in dryer. If connecting
to
existing
vent, make sure the vent is clean. The dryer vent must fit over the dryer exhaust
outlet
and inside the exhaust
hood.
Check that the vent is secured to exhaust
hood with
a
4" (102
cm) clamp.
2.
Move
dryer into its final location.
Do not crush or kink vent.
3.
(On gas models)
Check that there are no kinks in the flexible
gas line.
4.
Once the exhaust
vent connection
is made, remove
the corner
posts and cardboard.
LEVEL DRYER
Check the levelness
of the dryer. Check levelness
first side to side, then front to back.
If the dryer is not level, prop up the dryer using a wood block.
Use a wrench
to adjust the legs
up or down
and check again for levelness.
REVERSE DOOR
SWING
(OPTIONAL)
You can change your door swing from a right-side
opening
to a left-side
opening,
if desired.
1.
Place towel
(A) on top of dryer to protect
surface.
2.
Open
dryer door, Remove bottom
screws from cabinet
side of hinges
(D). loosen
(do not
remove) top screws from cabinet
side of hinges.
3.
lift door until top screws in cabinet
are in large part of hinge slot. Pull door forward
off
screws.
Set door (handle
side up) on top of dryer. Remove
top screws from cabinet.
4.
Remove screws attaching
hinges to door.
5.
Remove screws at top, bottom
and side of door (4 screws).
Holding
door over towel
on
dryer, grasp sides of outer door and gently lift to separate it from inner door. Do not pry
apart with
putty knife. Do not pull on door seal or plastic door catches.
18
Tabla de contenido
