During Use; Symbols; Instructions; Safety Devices - Metrix MX 604 Manual De Instrucciones

Chapter II

1.1.2. During use

Never exceed the limiting protection values given in the specifications specific to each
measurement type.

1.1.3. Symbols

Refer to the user's manual.
Incorrect use may result in damage to the device or its components.
Risk of electric shock

1.1.4. Instructions

•
Any adjustment, maintenance or repair to the instrument when live must be done by
qualified personnel after reading the instructions in this manual.
•
A qualified person is anyone familiar with the installation, construction, usage and
the dangers involved. This person is authorized to switch the installation and
equipment on or off in accordance with safety rules.
•
Before opening the device, always disconnect it from all measurement circuits and
make sure that there is no static electricity charge which could damage internal
elements.
•
When the instrument is open, some internal capacitors may maintain a dangerous
potential even after the instrument is switched off.
•
If there are any abnormal faults or constraints, take the instrument out of service and
prevent it from being used until it has been verified.
•
It is recommended to connect the cables or insert the element to be tested before
initiating the measurement process.
•
Place the switch in the OFF position when the instrument is not being used.
1.2.

Safety devices

•
The switch has two stops that prevent it from rotating.
•
It is impossible to access the battery box without firstly disconnecting measurement
cables.
•
An indicator (lamp on the instrument dial) indicates if any mains voltage is present.
1.3.

Guarantee

Unless specifically mentioned otherwise, the guarantee is applicable for 12 months after
the equipment has been handed over (extract from our general conditions of sale available
on request).
1.4.

Metrological verification

A periodic verification is necessary, as for all measurement or test instruments.
For checking and calibrating your instrument, please contact our accredited laboratories, the
manufacturer subsidiary or agent in your country.
Discharger tester
Appliance protected by dual
insulation or reinforced insulation
According to WEEE directive
Earth
2002/96/EC
9