Tabla de contenido
Idiomas disponibles
Idiomas disponibles
12: Level control - This knob sets the level of the audio signal being sent to the
headphones output (see #13 below).
13: Headphones output - Connect a stereo headphone to this standard 1/8" (3.5
mm) mini-phone jack in order to monitor the signal being output by the UM1. We
recommend the use of 30 ohm headphones. The level of the headphone signal can
be set by adjusting the Level control (see #12 above). Maximum output is 240 mW @
30 ohms).
14: Balanced output* - Use this electronically balanced low impedance (600 Ohm) mini-XLR jack when connecting the UM1 to professional
(+4) audio equipment. Pin wiring is as follows: Pin 1 ground, Pin 2 high (hot), and Pin 3 low (cold).
15: Meter switch - This three-position switch determines the function of the front-panel UM1 meter (see page #2 on page 9). In the left
"RF" position, the meter indicates the strength of the incoming RF signal. In the center "BATTERY" position, the meter indicates relative bat-
tery power, showing whether the installed battery is at low (red), mid (yellow) or high (green) strength. (Note: When the red "low" indicator
lights, performance is degraded and the battery needs to be replaced). In the right "OFF" position, the meter is disabled altogether, thus
conserving battery power.
* If required, both the unbalanced and balanced outputs can be used simultaneously.
Guided Tour - UM1 Receiver
9
Samson AirLine
12
13
RF
PHONES LEVEL
14
METER
BATT.
15
OFF
Tabla de contenido
