Dometic WAECO PerfectView CAM604 Instrucciones De Montaje página 36

Fitting the camera
If you want to screw on the camera with self-tapping screws (fig. f,
page 7):
A
NOTICE!
Self-tapping screws may only be fastened to steel metal with a
minimum thickness of 1.5 mm.
➤ Drill the holes, with a Ø of 6 mm, at each of the markings.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw on the camera bracket using 6 x 20 mm self-tapping screws.
If you would like to attach the camera with threaded screws fitted
through the construction (fig. g, page 7):
A
NOTICE!
Ensure that nuts cannot be pulled through the body shell when
they are tightened.
Use larger washers or metal plates if necessary.
➤ Drill the holes, with a Ø of 6.5 mm, at each of the markings.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw on the camera bracket using M6 x 20 self-tapping screws.
Depending on the thickness of the construction, you may require longer
threaded screws.
Creating a through-hole for the camera connection cable (fig. h,
page 8)
I
NOTE
If possible, use available openings, such as ventilation grilles, to
feed the connection cables through. If there are no existing ducts,
you must drill a hole of Ø 16 mm.
A
NOTICE! Beware of damage
Check beforehand that there is sufficient space on the other side
for the drill head to come out.
36
PerfectView CAM604
EN