Maintenance And Care; Troubleshooting - Battery Extender BE01253 Manual Del Usuario

Estimated run-times
APPLIANCE
TYPE WATTAGE
Cell phone
Fluorescent
light
Radios, fans
Depth finder
Camcorder 15 watts
Electrical tool 24 watts
Electric cooler 48 watts
Car vacuum,
80 watts
air compressor
NOTE: Actual time may vary. Times are based on
the internal battery being fully charged.
USING THE AIR COMPRESSOR
(Model BE01254)
WARNING. Read the instructions of the
product being inflated before using the
compressor. Avoid overinflation; do not
exceed the manufacturer's recommended
pressures. Do not leave the air
compressor unattended during use.

6. MAINTENANCE AND CARE

• Clean the clips and the case each time
you are finished using it.
• Recharge the unit once a month when
not in use.

7. TROUBLESHOOTING

PROBLEM
The unit won't jump start my
car.
EST
BE01253 BE01254
4 watts 13 hrs
4 watts 15 hrs
9 watts 6.7 hrs
9 watts 6.7 hrs
4 hrs
2.5 hrs
1.3 hrs 2 hours
0.8 hrs 1.8 hrs
Clamps are not making a good
connection to the battery.
Connections are reversed.
The unit's battery is not
charged.
The vehicle's battery is
defective.
The unit is not turned on.
1. Remove the air compressor hose from
2. Connect the adapter to the valve stem
34 hrs
34 hrs
3. Turn ON the inflator power switch and
14 hrs
14 hrs
4. When the desired pressure is
7 hrs
5 hrs
5. Wrap the compressor hose around
6. Allow unit to cool.
7. Recharge the unit before storing.
NOTE: The air compressor is rated for
150 PSI.
Estimated time for inflating
Vehicle tires 13-16"
Bike tires
Sports balls
These times are approximate. Use the air
compressor gauge to ensure the proper pressure
has been reached. Do not overinflate.
• Store clips on their support posts, to
ensure they do not come into contact
with any metallic surface.
• Never completely discharge the internal
battery.
POSSIBLE CAUSE
• 6 •
the storage cleats.
by threading it onto the end. If necessary,
use one of the additional adapters.
inflate to the desired pressure or fullness.
reached, put the inflator power switch
to OFF, unthread the connector from
the valve stem.
these cleats when it is not being used.
SOLUTION
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Disconnect the unit and
reverse the clamps.
Press the Battery Status button
on the front of the unit. The
LEDs will indicate the status of
charge.
Have the battery checked.
Turn the unit ON/OFF switch to
the ON position.
6-24 minutes
1-3 minutes
30 seconds