Maintenance And Care; Troubleshooting; Before Returning For Repairs - Battery Extender BE01255 Manual Del Usuario

6. MAINTENANCE AND CARE

• Clean the clips and the case each time
you are finished using it.
• Recharge the unit once a month when
not in use.

7. TROUBLESHOOTING

PROBLEM
The unit won't jump start
my car.
The unit won't power my
12V device.
The battery in the unit
won't hold a charge.
The compressor shuts off. The compressor is overheated. Allow to cool for a few minutes,
The unit's alarm is on.
The converter is on, but
the display only shows
err.

8. BEFORE RETURNING FOR REPAIRS

If these solutions do not eliminate the problem, or for more information
about troubleshooting, contact customer service for assistance:
For REPAIR OR RETURN, contact Customer Service at 1-800-621-5485.
DO NOT SHIP UNIT until you receive a RETURN MERCHANDISE AUTHORIZATION
(RMA) number from Customer Service at Schumacher Electric Corporation.
POSSIBLE CAUSE
Clamps are not making a good
connection to the battery.
Connections are reversed.
The unit's battery is not
charged.
The vehicle's battery is
defective.
The unit is not turned on.
The 12V device is not turned on.
The unit's battery is not
charged.
The 12V device draws more
than 15A or has a short circuit.
The battery is bad (will not
accept a charge).
Connections are reversed.
The internal battery is not fully
charged.
The device is drawing more than
200W or has a short circuit.
[email protected]
www.batterychargers.com
or call 1-800-621-5485
Monday-Friday 7:00
• 9 •
• Store clips on their support posts, to
ensure they do not come into contact
with any metallic surface.
• Never completely discharge the internal
battery.
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Disconnect the unit and reverse
the clamps.
Press the Battery Status button
on the front of the unit. The LEDs
will indicate the status of charge.
Have the battery checked.
Turn the unit ON/OFF switch to
the ON position.
Turn on the 12V device.
Check the battery charge status
by pressing the Battery Status
button.
Have a qualified service
technician replace the fuse.
Have the battery checked.
then try again.
Disconnect the jump starter and
reverse the clamps.
Recharge the unit.
Use only devices that draw less
than 1.7 amps of AC current.
to 5:00 CST
am pm
SOLUTION