Metabo C 7WDM Manual De Instrucciones página 32

English
NOTE:
* Over-amount of the gear oil will cause the over-high temperature and over-high
pressure of the gear box, which will lead to oil leakage.
* Replacing all old gear oil to the new one will keep the effi ciency of the saw.
* Do not use gear oil that has been used in this product for other purposes.
* Dispose of unnecessary gear oil according to local, state, federal laws and
regulations.
4. About handling the motor
Winding of the motor is said to be the heart of this tool. Exercise utmost caution not to
damage the winding by exposing it to wash oil or water.
NOTE:
* Accumulation of dust and the like inside the motor can result in a malfunction.
* After using the motor for 50 hours or so, carry out no-load running, and blow
in the dry air from a wind hole at the motor's rear. Such action is eff ective to
discharge dust and the like.
5. Inspecting the screws
Regularly inspect each component of the power tool for looseness.
Re-tighten screws on any loose part.
WARNING:
6. Inspecting the lower blade guard for proper operation
Before each use of the tool, test the lower blade guard to assure that it is in good condition
and that it moves smoothly.
Never use the tool unless the lower blade guard operates properly and it is in good
mechanical condition.
7. Storage
After operation of the tool has been completed, check that the following has been performed:
(1) Trigger switch is in OFF position,
(2) Power plug has been removed from the receptacle,
When the tool is not in use, keep it stored in a dry place out of the reach of children.
8. Cleaning
Periodically remove chips, dust and other waste material from the surface of the power
tool, especially from the inside of the lower guard with a damp, soapy cloth. To avoid a
malfunction of the motor, protect it from contact with oil or water.
9. Service parts list
A: KHA#
B: I.D. No.
C: Description
D: Size
E: Qʼty
32
To prevent personal injury, never operate the power tool if any
components are loose.