VESTEL EVC04-AC22 Serie Manual De Usuario página 18

1- Turn off the power of your charging station.
3- Toggle the position of 1st DIP switch using pointed
spudger or a plastic pointed tool. The DIP switch location
is as shown in below figure.
5- Turn on the power to your charging station. The
master and user RFID cards are erased.
IB v1.0 2019
2- Open the product cover as described in the installation
manual.
4- Close the product cover as described in the installation
manual.
6- The status information LED shall blink in red 20 seconds
during new master RFID card registration period. You may
register new master RFID card in 20 seconds by tapping
your new master RFID card. (If you do not have any card
tapped within this period, you won't be able to register
user cards and your station will stay in autostart charging
mode.) After registering new master RFID card, you can
follow the steps in section "Authorised Charging Mode"
for adding user RFID cards.
© 2019 Vestel - All rights reserved
"BEEP"
20sec
English - 16