Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4.5.2.2 Install the Remote TSTAT
1.
Turn off the power to both the pool/spa control
system and the heat pump unit.
2.
Remove the 4 screws that attach the service/access
panel to the heat pump unit and the cover to the
junction box (See Figure 15).
3.
Run the wires from the pool/spa control system
into the conduit connection labeled "low voltage
connection", located on the lower right hand side
of the heat pump (See Figure 15).
4.
Connect the wiring from the pool/spa control
system to the heat pump remote control terminal
(See Figure 16b).
5.
Restore power to the heat pump and the pool/spa
control system.
4.5.2.3 Confi gure the Control Panel
1.
Make sure the control is in the OFF mode.
2.
To enter the Service Setup mode, press and hold
the MENU, POOL, and SPA buttons for 5
seconds.
NOTE The display will revert back to OFF after one
minute since the last key press.
Green- Enabled
Red- On
LED
will not
come on
for Heat
Pump
Heat Pump/Chiller #1
Service/Wiring
Cover Panel
Figure 17. AquaLink RS to AE-Ti Heat Pump/Chiller Wiring
2.2K Ohms Resistor
in Solar Sensor
Terminals for Heat
Pump/Chiller
4 3 2 1
6 5 4 3 2 1
Connector for Low
Voltage Wires
3.
Press the Up or Down button to display
REMOTE. The SELECT REMOTE OFF
(default remote) appears, use the Up or Down
button to scroll through the Remote options. When
you reach REMOTE TSTAT, press the MENU
button to select the remote. Press POOL or SPA
to exit the Service Setup mode.
Press SPA. For heating, adjust the setpoint to the
4.
maximum setting. For chilling, adjust the setpoint
to the minimum setting.
Gas Heater Connections
Terminals 1 and 2
10 9 8 7 6 5 4 3 2 1
Battery
(9Volt)
Standard
High
Voltage
Relay
Low Voltage
Wiring to Low
Voltage Connector
on Heat Pump
To Pressure
Switch
Fireman's
Switch
From Fusible
Link
Gas Heater
Heat Pump/Chiller #2
Service/Wiring
Cover Panel
Connector for Low
Voltage Wires
Page 23
Capítulos
Tabla de contenido
Solución de problemas
