How To Wire Your Ceiling Fan; Installing The Canopy Housing - Fanimation The Cancun FP8012-220 Serie Manual Del Propietário Y Guía

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a

licensed electrician.

To avoid possible ﬁre or shock, be sure electricity is

turned off at the main fuse box before wiring.

(Figure 11)

▲WARNING

To avoid possible electrical shock, be sure electricity is

turned off at the main fuse box before wiring.

NOTE: If you are not sure if the outlet box is grounded,

contact a licensed electrician for advice, as it must be

grounded for safe operation.

1. Connect the green grounding lead from the hanger

ball and the green grounding lead from the hanger

bracket to the supply grounding conductor (this may

be a bare wire or wire with green colored insulation).

Securely connect wires with wire connectors supplied.

2. Securely connect the blue fan motor wire to the

blue supply (neutral) wire using wire connector

supplied. Securely connect the brown fan motor wire

and orange wire to the live supply (normally black

but marked as a live supply with red sleeving)

(Figure 12). Make sure all connections are secure.

▲WARNING

Check to see that all connections are tight, including

ground, and that no bare wire is visible at the wire

connectors, except for the ground wire. Do not operate

fan until the blades are in place.

damage could result.

1. Remove one of the two shoulder screws in the

hanger bracket. Loosen the second shoulder screw

without fully removing it. Assemble canopy by

rotating key slot in canopy over shoulder screw in

hanger bracket. Tighten shoulder screw. Fully

assemble and tighten second shoulder screw that

was previously removed. (Figure 13)

To avoid possible fire or shock, make sure that the

electrical wires are completely inside the canopy

housing and not pinched between the housing and the

ceiling.