WORKING WITH MEMORY
3. While holding down the ERASE button (15), press the F1-7 button
that you wish to erase. Note that the box surrounding the memory
location disappears.
4. Release the ERASE button.
DELETING ALL MEMORY CONTENTS
Hold down the EDIT and SSB buttons simultaneously, then press
RESET (2). This deletes the contents of all memory pages.
USING THE ATS MEMORY FEATURE
Auto Tuning Storage (ATS) automatically stores the strongest FM local
stations into memory, starting with page 99 and continuing down-
ward until all are stored, e.g. 99, 98, 97, etc.
To select and start ATS:
3. Hold down the F6 button for about 2 seconds, then release. Note
that the last chosen mode flashes in the screen.
4. While the mode flashes, perform quick, short presses of the F6 button
to select ATS, then press the PAGE/TIME (4) button.
5. Press the
Auto Tuning button for about two seconds to start the
ATS scan.
After the ATS scan, if too many memories are filled with
ATS NOTE:
static, try the scan again with the DX/LOCAL switch set in the LOCAL
position.
30
continued
8
USING THE LIGHT
The light illuminates the display and buttons. There are three light
modes.
Normal Mode: Pressing any button activates the light. The light
automatically turns off after 15 seconds.
Always-On Mode: When powered by its AC adapter, the light
remains always-on when the E5 is turned on.
Manual Light-On/Off Mode: If the light is off, pressing the LIGHT
button (7) activates the light for 15 seconds. Pressing it again within
15 seconds turns the light off.
9
USING THE EXTERNAL SHORTWAVE ANTENNA
SOCKET (45)
The external antenna socket is used to connect the E-5 to advanced
performance antennas using a 50 or 75-Ohm coaxial cable feed-line.
There are many such antennas on the market today. Typing in
'shortwave antennas' on your favorite Internet search site will provide
further information. Contact Eton Corporation if you have questions
about such antennas.
10
STEREO/MONO BUTTON (8)
When listening to FM stations this switch selects stereo or monaural.
Select stereo when using earphones. When not using earphones, it's
OK to leave it on stereo. In either case, if the FM signal is poor, selecting
mono may improve it.
E5
OPERATION MANUAL
31