Description Of Parts - Clatronic BKW 3615 Instrucciones De Servicio

4. Do not operate the appliance if package contents is
incomplete or appear damaged. Return it immediately to
the dealer.
NOTE:
There may still be dust or production residues on the ap-
pliance. We recommend that you clean the appliance as
described under "Cleaning".

Description of parts

1 Lid
2 Cup handle
3 Base unit
4 On/off switch and temperature control
5 Control lamp
Instructions
• This appliance can be used for heating and keeping warm
food in commercially available baby bottles and baby food
jars.
• We recommend not keeping food warm for long, but to
feed it as soon as possible. Especially at temperatures of
25°C to 42°C, the food is a very good breeding ground for
bacteria and germs. Any leftover food should not be reused
for the same reason.
• When heating convenience food, first remove the label
attached to the jar. Otherwise it could come off in the water
bath and clog the inside walls of the appliance or get into
the heating plate. Also remove the lid of the jar.
• We recommend filling the baby food into the cup provided
in order to heat it.
• Stir soft food from time to time.
• The lid is intended for protecting the appliance against dust. Remove it before operating the appliance.
Location
A skid-proof, even surface is suitable as installation location. It
should be resistant to moisture.
Adding water
• We recommend using boiled or filtered water in order to
reduce the formation of limescale.
• Always add water before operating the appliance.
The following table provides reference criteria for the heating time when heating to a temperature of 37°C:
Type of food
100 ml cold milk
250 ml cold milk
32
•
•
•
•
Electrical connection
1. Ensure that your mains power corresponds with the speci-
2. Turn the temperature control to the OFF position.
3. Connect the mains cable to correctly installed and earthed
Switching on / off
Use the temperature control to turn the appliance on or off. The
control lamp indicates the heating process.
Switch positions
Setting 1
Setting 2
Setting 3
Heating time
The heating time depends on different factors:
•
•
•
•
•
Maximum amount of
Vessel
water
Baby bottle
140 ml
Ø 55 mm
Baby bottle
140 ml
Ø 55 mm
The amount of water depends on the size of the vessel.
For more examples, please refer to the table in chapter
"Heating time".
When using the settings 1 and 2 , water should be
added to a maximum of approx. 1 cm below the edge of
the appliance with the vessel standing inside the appliance.
Make sure that no water spills over. Should the exterior
walls of the appliance should get wet though, wipe them
dry before connecting the appliance to the mains.
When using the cup provided with setting 3 , add a
maximum of 50 ml in order for the water not to boil over.
fications of the appliance. The specifications are printed on
the type label.
socket.
Heating the water
OFF
Approx. 40°C food that has been heated
Approx. 70°C
100°C
The type of food
The amount of food
Original temperature of the food
Temperature of the added water
Material of the vessel (glass/plastic).
Setting
Setting 1
Setting 1
Application
Turning off the appliance
E.g. for keeping warm
already
Slow heating
Fast heating
Approx. time
10 minutes
20 minutes