Guided Tour - Ut6 Beltpack Transmitter - Samson SYNTH SIX Manual Del Propietário

Ocultar thumbs

Contenido

página de 62

/ 62
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

NOTE: All descriptions below are the same for the

model UT6X transmitter.

1: Six-pin input connector - Connect your input

device (lavalier mic, headset mic or instrument cable)

here. A wiring diagram and chart (showing

connections for many popular lavalier and headset

mics) is presented on page 58 in this manual.

2: Audio on-off switch - When set to the "on"

position, audio signal is transmitted. When set to the "off" position, the audio signal is muted. Because

the carrier signal remains during muting, no "pop" or "thud" will be heard. Note that turning this off does

not turn off the transmitter power—it is simply a way to temporarily mute the transmission of audio signal.

If you don't plan on using the transmitter for extended periods, turn off the transmitter power by using the

power on-off switch (see #13 on the next page). As described in section 1j on page 3 of this manual,

when the UR6D Mute Indicator is lit, either the UT6 Audio switch is in the "off" position or the receiver's

currently selected Group and Channel do not match that of the transmitter.

3: Battery LED - This LED lights green when the UT6 is

powered on (see #13 on the next page) and the battery is

sufficiently strong. When battery voltage is low, this LED

lights red, indicating that RF performance is degraded and

that the battery needs to be replaced.

4: Battery cover release - Slide this release lever in the

direction of the arrow to open the UT6 battery cover.

5: Rotary Antenna - This transmitter antenna can be set to

any of three different positions. It should be placed straight

up for normal operations. See the "Setting Up and Using the

Synth Series 6 System" section on page 10 in this manual for

information about antenna positioning.

6: Instrument level control (trimpot) - If you are using the

UT6 with an instrument such as an electric guitar or bass,

use the supplied plastic screwdriver to set this input

sensitivity control to the optimum level. See the "Setting Up

and Using the Synth Series 6 System" section on page 10 in

this manual for more information.

7: Input switch - Set this to either the "INST" position

(if you are using the UT6 with an instrument such as an

electric guitar or bass) or to the "MIC" position (if you are

using it with a lavalier or headset microphone).

8: Mic level control (trimpot) - If you are using the UT6

with a lavalier or headset microphone, use the supplied

plastic screwdriver to set this input sensitivity control to the

optimum level. See the "Setting Up and Using the Synth

Series 6 System" section on page 10 in this manual for more

information.