Cleaning And Care; Bulb Replacement - OK. OTD 28111 Manual De Instrucciones

CLEANING AND CARE

• Warning! When cleaning, never use solvents or abrasive materials, hard brushes, metallic or sharp
objects. Solvents are harmful to human health and can attack plastic parts, while abrasive cleaning
mechanisms and tools may scratch the surface(s).
• Warning! Switch off the tumble dryer and let it cool down completely before cleaning.
• Clean the exterior surfaces of the product with a slightly damp cloth and dry them well. Make sure
that no water enters the product interior (e.g. at the switches).
Cleaning the lint filter
14 Pull out the filter and open it. Remove lint and fibers by hand. Wash the filter with tap water in order
to remove remaining lint or particles.
Reassembling is done in reverse order.
Cleaning the air condenser
The air condenser must be cleaned regularly from time to time.
Warning! Before opening the service flap, put a big cloths in front and below the flap. Large amount of
water may leak when opening the flap.
15 Push down both clips of the service flap and open it. Pull the levers of the sealing cap into the
correct direction in order to unlock the cap. Take off the sealing cap. Pull out the air condenser. If
necessary clean the air condenser with a soft brush and rinse thoroughly.
Warning! During reassembling make sure the sealing cap fits correctly and that it is correctly
locked by the two levers in order to avoid water leakage.
Cleaning air inlet
Regularly from time to time check the air inlet opening at the front side is free from obstacles and not
clogged or blocked.
Take of the service flap. Make sure the air inlet grill and foam filter are clean. Remove obstacles and
particles if any. Install the service flap.

BULB REPLACEMENT

Warning! Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of
electric shock.
Caution! Before changing the interior light of the oven, the cavity and the bulb must be completely
cooled down.
Take off the lamp cover and remove the defective bulb. Insert a new bulb type E14 and screw the lamp
cover.
IM_OTD28111_150320_V04_HR.indb 33
33
20/3/15 6:29 PM