Master BC 340 Manual De Instrucciones página 9

►2.2. Extract all items from the packaging.
►2.3. Verify if damage has occurred during
transport. Immediately inform the dealer
where the appliance was purchased if
this appears damaged.
►►3. ASSEMBLY
The device is equipped with wheels to fa-
cilitate handling. Depending on the model,
wheels can be found already installed or
not. Components equipped with relative
nuts and bolts are found inside the pack-
aging (Fig. 1).
►►4. OPERATION
WARNING: Thoroughly read the "IN-
FORMATION REGARDING SAFETY",
before switching the appliance on.
WARNING: Only use clean water to
prevent failures or other anomalies.
WARNING: Verify if your electronic
system is earthed correctly. Connec-
tion to the mains must be made in
compliance with the National Stan-
dards in force. Only power the appli-
ance the with voltage and frequency
as specified on the nameplate.
On the side of the cooler there are a series
of fittings and taps (Fig. 2-3-4):
► WATER FLOW ADJUSTMENT COCK
(Fig. 2): Used to adjust the water supply
to the cooler. With the cock completely
closed, you will have the maximum water
flow.
►DRAIN FITTING-TAP (Fig. 3): Used to
drain the water through the cooler pump.
To empty the tank connect the drain hose
to this fitting, enable COOL mode on the
control panel and open the cock.
►WATER SUPPLY FITTING (Fig. 4): Used
to supply water continuously and automati-
cally to the cooler. After filling, the appli-
ance can also be moved, always with the
utmost care.
Figures and texts of this book are protected by COPYRIGHT.
►►4.1. SWITCH-ON:
►4.1.1. Connect the hose of the water
supply to the cooler's fitting (Fig. 5).
►4.1.2. Refilling the water tank. When the
tank reaches the maximum level, a float
automatically stops the flow of water.
CAUTION: You can operate the cooler
while connected to and continuously fed by
the water supply.
►4.1.3. Check that there were no leaks
during refuelling.
►4.1.4. Connect the power plug to the
mains (Fig. 6).
►4.1.5. Press the "ON/OFF"/"POWER"
button to switch on the appliance (Fig. 9).
►►4.2.1. CONTROL PANEL AND
FUNCTIONS (Fig. 7):
►ON/OFF: Turns on or off the device.
►SPEED: Increases or decreases the
ventilation speed of the device. You can
choose from three speeds.
►COOL: Enables or disables the cooling
mode.
►ANION: Enables or disables the ionisa-
tion mode, that is, the release of nega-
tive ions in the atmosphere, to make air
healthier.
►TIMER: Enables to activate or deacti-
vate the delayed switch-on or switch-off
mode.
-Delayed switch-on: When the cooler is
on, press the "TIMER" button repeat-
edly until the desired time is displayed
(the number flashes), then switch off the
equipment.
-Delayed switch-off: When the cooler is
on, press the "TIMER" button repeatedly
until the desired time is displayed, then
the switch-off time is set.
NOTE: When the cooler emits an
acoustic beep, it means that the tank
is empty and must be filled again
("COOL" function). To deactivate the
acoustic beep, deactivate the "COOL"
function.
en