Sears Kenmore Pro 79079523600 Manual De Instrucciones página 4

Three Conductor Wire Connection to Range
(The 3-conductor cord or cable must be replaced with a
4-conductor cord or cable where grounding through the
neutral conductor is prohibited in new installations,
mobile homes, recreational vehicles or in other areas
where local codes do not permit neutral grounding)
If local codes permit connection of the frame grounding
conductor to the neutral wire of the power supply cord
(see Figure 3):
1. Remove the 2
screws at the
lower end of the
rear wire access
cover, then
remove the
access cover to
expose range
terminal
connection block
(see Figure 2).
Rear wire
Pressure regulator access cover
location Figure 2
Risk of fire or electrical shock exists if
an incorrect size range cord kit is used, if the
Installation Instructions are not followed, or if the
strain relief bracket is discarded.
Four Conductor Wire Connection to Range
(mobile homes)
1. Remove the 2 screws at the lower end of the rear wire
access cover, then remove the access cover to expose
range terminal connection block (see Figure 2).
2. Remove the three loose nuts (after you removed the
rubber band) on the terminal block using a 3/8" nut
driver or socket.
3. Remove the grounding strap from the terminal block
and from the appliance frame.
4. Connect the ground wire (green) of the power supply
cord to the frame of the appliance with the ground
screw, using the hole in the frame where the ground
strap was removed (see Figure 4).
5. Connect the neutral wire of the power supply cord to
the center silver-colored terminal of the terminal
block, and connect the other wires to the outer
terminals. Match terminal and power supply wires by
color.
6. Replace the 3 nuts on the terminal block (see figure 4).
7. Replace the terminal cover using the 2 screws
removed on step 1.
Terminal
2. Remove the 3 loose nuts on the terminal block using
3/8" nut driver or socket.
3. Connect the neutral white wire of the power supply
cord to the center silver-colored terminal of the
terminal block, and connect the other wires to the
outer terminals. Match terminal and power supply
wires by color.
4. Replace the 3 nuts on the terminal block (see figure 3).
5. Replace the rear wire access cover using the 2 screws
removed on step 1.
Colored
Terminal
Terminal -
Block
1-1/8" Dia.
Direct
Connection
Hole. Punch
out knockout
for 1-3/8" Dia.
Cord Kit
A user supplied
strain-relief
be installed at this
location. To240 V receptacle
NOTE: Be sure to remove the f_/
supplied grounding strap.. -_
Figure 4
ig
A strainrelief Strap
supplied 1-1/8" Dia. Direct
user must be Connection Hole.
installed at this Iocati( Punch out knockout
for 1-3/8" Dia.
Cord Kit Hole
Figure 3
4