Care And Cleaning; General Cleaning; Adhesives; Door Gaskets - Sears Kenmore 67272 Manual Del Propietário

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Care and Cleaning
_kWARNING:
Disconnect power to refrigerator
before cleaning to avoid electrical shock which can
cause severe personal injury or death. After cleaning,
restore power.
_
CAUTION: Read and follow all manufacturer's
cleaning directions to avoid personal injury or property
damage.
4.
Raise stabilizing legs (some models) by turning
counterclockwise.
,_
CAUTION: Protect soft vinyl or other flooring
with cardboard, rugs or other protective material to
arc d property damage,
5
Pull refrigerator' away from wall.. Run a vacuum
brush across grille on back of refrigerator..
General
Cleaning
1
Wash surfaces and exterior with 4 tablespoons
baking soda dissolved in 1 quart warm water and a
soft, clean cloth.
2
Rinse surfaces and exterior with warm water Dry
surfaces with a soft, clean cloth.
&
DO NOT USE the following items:
• abrasive orharsh cleaners, ammonia, chlorine
bleach, etc
• concentrated detergents or solvents
• metal scouring pads
These items can scratch, crack, and discolor
surfaces.
4
Do not place buckets, shelves, etc., in dishwasher.
Adhesives
1.
Remove adhesive residue from refrigeratorsurfaces
by rubbing toothpaste into adhesive with fingers until
adhesive loosens
2
Rinse surface with warm water. Dry surface with a
soft, clean cloth°
Door Gaskets
1.. Clean door gaskets every 3 months according to
General Cleaning instructions
Clean any spills
immediately.
2.. Apply a light film of petroleum jelly to keep gaskets
pliable.
Condenser
Coils
Clean condenser coil behind toe grille every 3 months to
ensure maximum performance of refrigerator:
Accumulated dust and lint may cause the following:
reduced cooling performance
increased energy usage
premature part faiture
1o Remove toe grille by holding ends and pulling away
from refrigerator'
2.
Clean front surface of condenser coi! with a vacuum
cleaner hose nozzle.
&
Replace toe grille by inserting clips in holes and
snapping in.
Glass Shelves
CAUTION: Handle tempered glass shelves
carefully to avoid personal injury or property damage.
Shelves may break suddenly if nicked, scratched, or
exposed to sudden temperature change.
Remove shelf by lifting front, releasing hooks from metal
track then pulling out. Place shelf on a towel.. Allow shelf
to adjust to room temperature before cleaning
Clean crevices by completing the following:
I..
Dilute mild detergent and brush solution into crevices
using a plastic bristle brush. Let sit for5 minutes.
2.. Spray warm water'into crevices using faucet spray
attachment..
3.
Dry shelf thoroughly and replace shelf by inserting
hooks into metal track and lowering it from the front.
Odor Removal
i..
Remove all food and disconnect power to refrigerator,
2.
Clean all interior surfaces including ceiling, floor, and
walls according to General Cleaning instructions
above. Pay special attention to corners, crevices, and
grooves. Include all drawers, shelves, and gaskets.
3.
Connect power to refrigerator and return food to
refrigerator Wash and dry all containers. Wrap foods
in tightly sealed container's to prevent further odor:
After 24 hours, check if odor has been eliminated..
Complete steps 4-9 if odor has not been eliminated
4.
Place crispers on top shelf of refrigerator section.
Pack refrigerator and freezer sections, including
doors, with crumpled sheets of newspaper:
5.
Place charcoal briquettes randomly throughout
newspaper.
6.
Close doors and let stand 24-48 hours.
7.
Remove charcoal briquettes and newspapers..
8.
Complete steps 2-&
If odor is still not eliminated,
contact a Sears Service
Center.
]4
Tabla de contenido
loading

Tabla de contenido