Danby Silhouette DWC612BLP Manual Del Propietário página 3

SAFETY INSTRUCTIONS
ATTENTION
GROUNDING INSTRUCTIONS
This appliance must
the event of an
grounding reduces the risk of electrical shock by providing
an escape wire for the electrical current. This appliance is
equipped with a cord having a grounding wire with a
grounding plug. The plug must be plugged into an outlet
that is properly installed and grounded.
WARNING - Improper
grounding plug can result in a risk of electric shock.
Consult a qualified electrician or serviceman if the
grounding instructions are not completely understood, or if
the doubt exists as to whether the appliance is properly
grounded.
DO NOT USE AN EXTENSION CORD
Use an exclusive wall outlet. Do not connect your wine
cooler to extension cords or together with any other
appliance in the same wall outlet. Do not splice the cord.
IMPORTANT WARNING
An empty wine cooler is a very dangerous attraction to
children. Remove either the gasket, latches, lids or doors
from unused appliances, or take some other action that
will guarantee it harmless.
DON'T WAIT! DO IT NOW!
SPECIAL INSTRUCTIONS
You must remove the bottom door support on the bottom left
hand side of the unit before you can open the door. (See Fig. A)
FIG. A
be grounded.
electrical short circuit,
use of
INSTALLATION INSTRUCTIONS
Remove the exterior and interior packings, wipe the outside thoroughly with a
soft dry cloth and the inside with a wet, lukewarm cloth. Avoid placing the
cabinet in a narrow recess or near any heat source, direct sunlight, or moisture.
Let air circulate freely around the cabinet. Keep the rear of the wine cooler 5
inches away from the wall.
In
Location
1. Select a place with a strong, level floor.
2. Allow 5 inches of space between the back of the wine cooler and any adjacent
wall.
3. Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating.
Heat sources nearby will cause higher electricity consumption.
the
To avoid vibration, the cabinet must be set level. To start the wine cooler, turn
the temperature control to the position corresponding to the desired cooling.
The wine cooler temperature will vary depending on the quantity of bottles
stored and on the frequency with which the door is opened.
To turn "OFF" the wine cooler permanently, you must disconnect the power cord
from the electrical outlet. There is no "Off" position (setting) available on the
electronic control panel. When the wine cooler is not to be used for a long
period of time, disconnect the plug and leave the door partially open.
NOTE: Wait 3 to 5 minutes before restarting if operation has been interrupted.
Interior Light
The operation of the interior light is "manually" controlled and does not operate
with the opening or closing of the door. To operate the light; manually press
the "light" key pad located on the electronic control panel NOTE: Leaving the
interior light on for extended time periods, will increase the internal temperature
of the cabinet
Defrosting
Your wine cooler is designed with an "Auto-Cycle" defrost system. What is Auto
Cycle defrost?
The refrigerated surfaces of the fresh food compartment defrost automatically,
during the "off" cycle of the cold control. (thermostat) Defrost water from the
fresh food compartment is disposed of automatically, by means of being
channeled onto a drip tray located on the compressor. Heat transfer from the
compressor causes the defrost water to evaporate.
ELECTRONIC CONTROL OPERATION;
The electronic LED display on this wine cooler is programmed to display
(independently) the following temperature (only) information.
"INTERNAL CABINET TEMPERATURE: This setting is represented by a
"steady" state (non-flashing) LED display and is the normal (LED) default setting
during operation.
SET OPERATING TEMPERATURE: This setting is represented by a "flashing"
LED display and can only be programmed (SET) by pressing and releasing
either of the +/- (temperature) keys during operation. NOTE: The set
temperature can only be adjusted/set while the LED is in "flashing" mode.
2
OPERATION