Phonic PAA3 Manual Del Usuario página 8

9. Male XLR Socket (Line Output)
Through this XLR male connector, users can send out
three built-in audio test signals: pink noise,1 kHz tone,
and the polarity signal. The output level is balanced
-10dBu under a 6V DV power supply.
10. Female XLR Socket (Line Input)
This port allows you to send balanced, linelevel input
to the PAA3. This signal input allows you to measure
signals in dBu, dBV or AC voltage for balanced
and unbalanced signals. It is particularly useful for
checking the phase of a connections.
11. Contrast Control
By adjusting this control, users can change the
contrast of the PAA3's LCD screen to better adapt
the device to different lighting conditions.
12. Power Lock
Set this switch to the "ON" position before turning on
the PAA3. You can set to the "OFF" position to prevent
accidental powering up of the PAA3 when the unit is
not in use. It is recommended that users move this
switch to the off position when the PAA3 will not be
used for a long period of time. Provided that the shut
down procedure was followed correctly, turning this
switch off after saving your settings will not cause the
loss of any data.
13. Built-in Microphone
Turn this accurate built-in Omni-directional mic to
operation position (stands 45 degrees) by pressing
the axis base. Always press the axis base before
rotating the mic, as it is locked into place. If you
attempt to rotate the mic without pushing in first, you
could very well damage your PAA3.
14. Stand Mount
A stand mount is located on the back for connection
to a tripod or any other stand that has a standard #6
- 20 connecting screw, often found on camera tripods.
Also included is a stand adapter, allowing the PAA3
to be mounted on microphone stands as well.
4
10
12
15. Battery Compartment
The PAA3 requires four AA batteries for operation.
Under normal conditions, the PAA3 can last for up to
seven hours of continuous operation with the use of
Duracell alkaline batteries.
9
13
11
14
15
PAA3