König Electronic CMP-USBVGA11 Manual De Uso página 5

Be the primary monitor:
To make the add-on monitor the primary display:
1) Position the mouse anywhere on your computer desktop, right click and select Personalize>Display
Settings on Vista or Properties>Settings on XP/2000
2) In the display dropdown menu, select the option ends with Displaylink Graphics Adapter.
3) Check the This is my main monitor box on Vista or Use this device as the primary monitor box on
XP/2000. On some PCs and laptops it is necessary to disable the main display(i.e.uncheck the Extend
the desktop onto this monitor or Extend my windows desktop onto this monitor box for the main
display) as part of the same settings change.
4) Click OK to close the settings screen. The add-on monitor stays primary if the PC enters hibernate or
suspend mode or is rebooted. If the add-on monitor is unplugged, the main display becomes primary
again.
Adjusting resolution, color depth and refresh rate:
** Note that interlaced modes are not supported.
** Only support by 1600*1200 model
About the resolutions and refresh rates available to users.
The resolutions and refresh rates available to the user
through Windows are a comprise of the support from the
following elements:
• The USB display adapter.
• The primary monitor and the add-on monitor.
• The primary video card on your computer and installed
drivers
Therefore, for example, if your monitor doesn't support a
resolution of 1600*1200 is not possible even you are using a
USB display adapter with 1600*1200 support.
This ensures that the monitor cannot be put into an
unsupported. This ensures that the monitor cannot be put
into an unsupported mode, which might damage it.
If cloning the primary display, the video component will try
to use the preferred monitor mode. In some cases, this may
not be the most appropriate mode for the cloned desktop.
It is recommended that the primary display resolution be
changed to closer match the Default resolution of the add-on
monitor.
To configure the three components of a screen mode, follow
these steps;
1) Position the mouse anywhere on your computer
desktop, right-click and select Personalize>Display
Settings on Vista or Properties>Settings on XP/2000
2) In the Display dropdown menu, select the option Ends
with Displaylink Graphics Adapter.
3) To change the screen resolution or color quality, select those options on the screen. Be sure to select
one of the supported resolutions and color quality numbers in the table above. For an add-on monitor,
you can also select any resolution or quality supported by that monitor.
4) To change the refresh rate, click Advanced .. and then click Monitor.
5) Select a refresh rate from the Screen refresh rate drop-down list and then click Apply.
6) Click OK to close the settings screen.
CMP-USBVGA11.indd 5
5
09-7-30 7:41