Connecting The Videophone - Extel WEVP 626 E BIS Instrucciones De Uso E Instalación

4. WIRING
a.

Connecting the videophone

Use the following wires:
1. Connect the wires securely following the wiring diagram below.
2. To connect the video camera, 4 wires are needed for all the functions.
C :
AUTION UNDER NO CIRCUMSTANCES SHOULD THE WIRES BE DOUBLED TO MAKE THEM THICKER
•Terminal "1"
on the screen to terminal
•Terminal "2"
on the screen to terminal
•Terminal "3"
on the screen to terminal
•Terminal "4"
on the screen to terminal
b. Connecting an electrical strike or lock.
When the installation includes a catch or an electric lock, provide two extra wires to connect the catch to the
monitor (see wiring p.12).
Connect it to terminals 5 and 6 on the back of the monitor.
Warning: the power supply for the catch or the electric lock is provided by an independent transformer which is
not supplied with the kit. (rExtel ref.: WETR 14602).
Note this function is only valid when the screen is switched on.
The electrical strike or lock you will install will imperatively be equipped with a mechanical memory as every EXTEL
•
references For wiring, refer to the label at the rear of the monitor and the camera
• lengths up to 30 metres: 4 x 6/10 wires + 2
• lengths between 30 and 100 metres: 4 x 1.5 mm
"1"
of the video camera.
"2"
of the video camera.
"3"
of the video camera.
"4"
of the video camera.
b
a
6
5
4
3
2
1
6
5
4
3
2
1
23GB
wires + 2
2
1 2 3 4
c