Cleaning The Spray Tip; Cleaning The Filter; Replacing The Valve Spring Unit; Choosing The Correct Spray Gun Filter - SprayTECH ED655 Manual Del Propietário

Cleaning the Spray Tip

1. Flush the gun with solvent immediately after the work is
completed.
2. Oil the sliding pins to prevent them from seizing up.
Should the spray tip become clogged,
reverse the spray tip with the lever and
pull the trigger. Once the obstruction
comes out of the spray tip, release the
trigger, reverse the spray tip back to the
spray pattern setting, and resume
spraying.
WARNING
Do not attempt to clean the tip with your finger.
Do not use a needle or other sharp pointed instrument to
clean the tip. The hard tungsten carbide is brittle and can
be chipped.

Cleaning the Filter

Clean the filter with a brush dipped in solvent. Never poke the
filter with a sharp instrument.
Changing the Filter
1. Pull the trigger guard forward
so that it comes loose from
the handle.
2. Unscrew the handle from the
housing and remove the old
filter.
3. Slide the new filter, taper end
first, into the gun housing.
4. Replace the handle, washer
and spring. Screw the handle
into the housing until hand-tight. Replace the trigger
guard.

Replacing the Valve Spring Unit

NOTE: Replace the packing if the spray gun is
disassembled. Replace the sliding pins if they
are worn.
1. Unscrew the spray tip.
2. Lock the gun in the ON position and remove the diffuser
with a wrench
3. Unlock the gun.
4. Unscrew the nut
with a wrench
Gun Housing
and remove the
Valve Spring
retainer block.
5. Remove the
Diffuser
sliding pins with
care and store
them in a safe
place so they will
not be lost.
6. Drive the valve
spring unit forward from the back of the retainer block.
Use the handle of a wooden hammer or similar soft tool to
avoid damaging the valve spring unit.
English
Gun Housing
Filter
Handle
Sliding Pin
Retainer Block
Unit

Choosing the Correct Spray Gun Filter

Use the proper gun filter based on the type of material being
applied as shown below.
Part no. Application
0089960 Synthetic resin,
enamels, clean
varnishes, stains
azures
0089959 Base coat enamels,
primer enamels,
fillers, marking paints,
textured enamels
0089958 Emulsions,
latex paints,
acrylic paints
0089957 Filler paints,
large area surfaces

Cleaning the Hopper Screen

The screen at the bottom of the paint hopper may need
cleaning periodically. Check it every time you add paint.
Remove the screen by pulling it out of the hopper with a pliers.
Clean the screen with water or solvent and a soft-bristle brush,
if necessary.

Tightening the PRIME/SPRAY Knob

Sometimes the two allen screws holding the PRIME/SPRAY
knob outer cover will vibrate loose. This allows the cover to
turn without changing the valve setting. If this happens,
loosen the screw with a 1/16 allen wrench, turn the knob to
SPRAY and tighten the screw.
Nut
12 © SprayTECH Corporation. All rights reserved.
Filter Mesh Color of
type number Filter
body
Extrafine 0.084 mm red
Fine 0.140 mm yellow
Medium 0.315 mm white
Coarse 0.560 mm green