Troubleshooting - Teac SR-L230i Manual Del Usuario

If you have problems with your system, look through
this chart and see if you can solve the problem
yourself before calling your dealer or TEAC service
center.
General
No power
e Check the connection to the AC power supply.
Check and make sure the AC source is not a
switched outlet and that, if it is, the switch is
turned on. Make sure there is power to the AC
outlet by plugging another item such as a lamp or
fan into the outlet.
No sound from speakers.
e Select the source by pressing the FUNCTION
button.
e Adjust the volume.
e Pull out the headphone's plug from the PHONES
jack.
e If the MUTING indicator lights on the display,
press the MUTING button.
The sound is noisy.
e The unit is too close to a TV or similar appliances.
Install the unit apart from them, or turn them off.
Remote control doesn't work.
e If the battery is exhausted, replace it with a new
one (see page 5).
e Use remote control unit within the range (5 m)
and point at the remote sensor on the front
panel.
e Clear obstacles between the remote control unit
and the main unit.
e If a strong light is near the unit, turn it off.

Troubleshooting

iPod Player
Cannot insert the iPod.
e Check the dock adapter (see page 10).
e Remove dust or obstacles from the Dock
connector of the SR-L230i and the iPod, and
insert the iPod again.
Will not play.
e Remove the iPod from the dock, wait a few
seconds, and insert it again.
e Software update may solve the problem. Visit the
Apple website and download the latest iPod
Software (see page 11).
Cannot operate the iPod.
e Set off the HOLD switch of the iPod.
Tuner
Cannot listen to any station, or signal is too
weak.
e Tune in the station properly.
e Rotate the FM or the AM antenna until you get
stations clearly.
If normal operation cannot be recovered, unplug
the power cord from the outlet and plug it again.
Maintenance
If the surface of the unit gets dirty, wipe with a soft
cloth or use a diluted mild liquid soap. Be sure to
remove any excess liquid completely. Do not use
thinner, benzine or alcohol as they may damage
the surface of the unit. Allow the surface of the
unit to dry completely before using.
23