Numark Stealth Control Guida Rapida página 6

13. PH MIX – Adjusts the balance between the
Monitor and Master channels in the
headphones. Please note that, unless you
are using a multiple output audio interface,
the Monitor and Master Mix channels will
be the same.
14. PH VOL –
headphone mix level.
unless you are using a multiple-output
audio interface, the Monitor and Master Mix
channels will be the same.
15. PFL – Press the PFL button to send the
music playing on the deck to the Monitor
channel. Please note that if you are not
using a multiple-output audio interface, the
Monitor and Master Mix channels will be
the same.
16. PITCH – Changes the pitch or tempo of the
music playing on that deck.
17. FINE PITCH
adjustments to the music on the deck.
18. TAP – Tap this button in time with the
beats of the music on that deck. This will
enter a new BPM ("beats per minute")
reading for that track.
19. KEY – Engages the Master Tempo feature,
which locks the musical key of the track to
the original key (as if it were playing with
0% pitch adjustment). You can then adjust
the tempo of the track without affecting its
key or pitch.
20. SYNC – Synchronizes the music playing on
that deck to the music playing on the other
deck.
21. PITCH BEND -/+ – You can use these two
pitch bend buttons to temporarily adjust the
pitch and tempo of the music playing on
the corresponding deck.
typically used to make small adjustments
when mixing two tracks so their beats
occur synchronously.
22. LOOP IN – Press this button to set the
starting point of a loop.
23. LOOP OUT – Press this button (after
pressing LOOP IN) to set the ending point
of a loop. Once you press it, you will jump
back to the Loop In point and the loop will
be active. To turn a loop off, simply press
LOOP OUT again.
24. FX AMT – Adjusts how much of the
selected effect will be heard in the Master
Mix. If the knob is all the way down, you
will hear only the original ("dry") sound. If
the knob is all the way up, you will hear the
maximum amount
sound.
25. SELECT – Selects an effect to be applied
to the Master Mix.
This knob adjusts
Please note that,
– Makes fine
Pitch bend is
of effected ("wet")
26. PAR – Adjusts the amount of the
designated Effect Parameter.
note that this parameter will vary
depending on the selected effect.
27. ON / OFF – Press this button to turn the
master effect on and off.
the
28. FILTER AMT – Adjusts the amount of
filter applied to the music on that deck.
The center position is zero. Turning the
knob clockwise will increase the amount
of high-pass filter.
counter-clockwise
amount of low-pass filter.
29. FILTER ON / OFF – Activates or
deactivates the filter on that deck
pitch
6
Please
Turning the knob
will increase the
.