Layout And Items Supplied - EINHELL BT-PS 800 Manual De Instrucciones

Anleitung_BT_PS_800_SPK7__ 11.04.14 07:43 Seite 13
(dependent on time and the number of cycles).
The battery must be replaced at the latest when
its capacity falls to just 80% of its capacity when
new.
3. Do not throw battery packs into an open fire.
There is a risk of explosion!
4. Do not ignite the battery pack or expose it to fire.
5. Do not exhaustively discharge batteries.
Exhaustive discharge will damage the battery
cells. The most common cause of exhaustive
discharge is lengthy storage or non-use of partly
discharged batteries. End the process as soon as
the performance of the battery falls noticeably.
Only place the battery in storage after it has been
fully charged.
Warning! Information on chargers and the
charging process
1. Please check the data marked on the rating plate
of the battery charger. Be sure to connect the
battery charger to a power supply with the voltage
marked on the rating plate. Never connect it to a
different mains voltage.
2. Protect the battery charger and its cable from
damage and sharp edges. Have damaged cables
repaired without delay by a qualified electrician.
3. Keep the battery charger, batteries and the
cordless tool out of children's reach.
4. Do not use damaged battery chargers.
5. Do not use the supplied battery charger to charge
other cordless tools.
6. Do not over-charge batteries.
Do not exceed the maximum charging times.
These charging times apply only to discharged
batteries.
Protection from environmental influences
1. Wear suitable work clothes. Wear safety goggles.
2. Protect your cordless tool and the battery
charger from moisture and rain. Moisture and
rain can cause dangerous cell damage.
3. Do not use the energy station or the battery
charger near vapors and inflammable liquids.
4. Use the battery charger and cordless tools only in
dry conditions and an ambient temperature of 10-
40°C.
5. Do not keep the battery charger in places where
the temperature is liable to reach over 40°C. In
particular, do not leave the battery charger in a
car that is parked in the sunshine.
6. Protect batteries from overheating. Overloads,
over-charging and exposure to direct sunlight will
result in overheating and cell damage. Never
charge or work with batteries which have been
overheated – replace them immediately if
possible.
7. Storage of batteries, battery chargers and
cordless tools. Store the charger and your
cordless tool only in dry places with an ambient
temperature of 5-30°C. Protect them from
humidity and direct sunlight. Place only fully
charged batteries in storage.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fires.
Compressor
¼
Never use the compressed air to clean your
clothing.
¼
Do not blast persons or animals with
compressed air.
¼
Keep all ventilation slots clean and free of dirt.
¼
Take steps to ensure that the compressor does
not draw in any dust or contaminants.
¼
Do not use the compressor to fill high-pressure
tires, such as those on heavy duty trucks,
tractors and trailers.
¼
If you want to fill several tires, let the compressor
rest for approximately 15 minutes between each
filling. The maximum operation time of the unit is
10 minutes. Do not exceed this limit!
Environmental protection
Please remember that packaging, old batteries and
defective storage batteries do not belong in your
household refuse. Dispose of these items through
the proper channels.

2. Layout and items supplied

2.1 Layout (Fig. 1/4)
1. Jump starting lead red (+)
2. Battery charging jack
3. "Battery charging jack" LED
4. "Charging status indicator ON" button
5. Charging status indicator
6. Work light
7. Switch for work light
8. 12V/10A connector
9. Jump starting lead black (-)
10. Pressure gauge for compressor
11. Switch for compressor
12. Charging unit
13. 12V adapter cable
GB
13