Idiomas disponibles
Idiomas disponibles
3. Insert locking tool, allen wrench, or screwdriver,
(E), into gear case. Turn head counterclockwise
to tighten. Remove locking tool, allen wrench, or
screwdriver.
Procedure – Ryobi Straight Shaft Trimmers
1. Identify the correct trimmer in the Application Fit-
up Chart, see pages 5-6. Locate and record the
RL REF#.
2. Remove the existing trimmer head. Do not
remove the upper fixing plate from the gear case.
3. Ryobi models with a flat fixing plate (main image)
will use an adapter (D), models with step down
(Image –1a) will use washer (C) and no adapter.
Install as shown:
A - Gear case
B - Rapid-Loader Trimmer Head
C - RL42 – 3/8 x 1 3/8". silver fender washer
D - 8mm triangle adapter
E - RL70 – M8
A
B
or
D
E
4. Insert locking tool, allen wrench, or screwdriver,
(F), into gear case. Turn head counterclockwise
to tighten. Remove locking tool, allen wrench, or
screwdriver.
X7672053800
E
1.25 blue left-hand nut
x
C
Step down
Inserting Trimmer Line
Insert one piece of trimmer line through eyelet on
each side of head. Route line as shown.
Accepts line diameter 0.080 - 0.130 in.
Removing Trimmer Line
Pull line out of head in direction shown:
For Additional Fit-Up Information
Please visit the Product Support section at
www.echo-usa.com.
1a
- 4 -
©2018 ECHO Incorporated. All Rights Reserved
