Makita DFL201R Manual De Instrucciones página 9

For LED#B
1
2
► 1. LED#B1 2. LED#B2
Description Viewed color
LED#B Green
LED#B Red
Note 1: Refer to a instruction manual of receiver (acces-
sory) RCV02 when connecting it.
Note 2: Communication distance: 10 m or less (variable
up to 10 m depending on the operation environment)
CAUTION:
• Make sure that LED#B2 does not light up before removing a battery cartridge from the tool. If
a battery cartridge is removed while LED#B2
lights up or blinks, tools stored data will be
deleted.
Adjusting the fastening torque
When you wish to drive machine screws, wood screws,
hex bolts, etc. with the predetermined torque, adjusting
the fastening torque as follows.
1. First remove the battery cartridge from the tool.
2. Loosen and remove the screw that secures ring.
(Loosen the two screws that secure ring only for
DFL201R)
1 lights up when the tool is connected to a receiver.
when the tool is on the step of being connected to a
2 blinks
receiver. (Note 1)
one of the status below
3-1 when the battery cartridge is removed from the tool.
when the tool is left idle for more than 15 minutes
3 is turned off 3-2
with a installed battery cartridge.
when the tool is not within the transmission
3-3
distance. (Note 2)
when the tool's stored number of data reaches its
1 lights up
storable number of data.
when the tool's stored number of data is equal to or
2 blinks
smaller than its storable number of data.
when the tool has no stored data to transmit to a
3 is turned off
receiver.
9 ENGLISH
LED indicator / Beeper on the tool shows the following
functions.
View and status
1
► 1. Screw
3. Rotate the ring in the front of the tool by hand so
that a hole can be seen below the ring.
4. Place the battery cartridge in place and pull the
switch trigger. Release it so that the adjusting ring
rotates and becomes visible in the hole. And then
remove the battery cartridge.