Common Problems And Solutions; Possible Cause - Danby Designer DDW399W Manual Del Propietário

Common Dishwashing Problems and Solutions
PROBLEM
Dishwasher will not start
Dishes not clean
Chipping or breaking
glassware
Water remains in bottom
of dishwasher

POSSIBLE CAUSE

• Dishwasher not receiving
electrical power.
• Door is unlatched.
• Dishwasher not level.
• Improper loading.
• Spray arm not rotating freely.
• Not enough detergent and/or
improper detergent being used.
• Improperly prepared dishes.
• Water inlet hose kinked/bent
due to improper installation.
• Improper loading of dishes.
• A small amount of water
(in sump area) is normal.
• Excessive amount of water;
Cycle not completed.
7
POSSIBLE SOLUTION
• Check electrical connection
Fuse/circuit breaker.
• Close and latch door.
• Level unit.
• Arrange dishes so spray action
reaches all surfaces.
• Do not overload dishwasher.
• Check spray arm to make sure
nothing (i.e. cutlery) is
obstructing spray arm rotation.
• Check if filter screen has
become dislodged and
obstructing spray arm rotation.
• Use more dishwasher detergent.
• Do not use detergent that is
hard or caked.
• Use only a recommended
dishwasher detergent.
• Excess food soil and liquids
should be removed from dishes
before loading.
• Eliminate kink or bend from
inlet hose.
• Do not overload dishrack. Load
glasses on the upper rack only,
not over dishrack pins. Glasses
loaded over dishrack pins are
not properly supported and
subject to damage.
• This is necessary to keep the pump
primed and is drained automatically
at the beginning of each cycle.
• Allow dishwasher to complete
full cycle.