Tabla de contenido
Idiomas disponibles
Idiomas disponibles
acute inflammation and peripheral vascular disease or decreased
sensation of any extremity before using.
• Discontinue use and consult a physician if the paraffin wax feels too
warm or if it does not feel warm enough. This may indicate a possi-
ble physical problem.
• Discontinue use and consult your physician if dermatitis, discomfort,
irritation, or pain occurs from continued paraffin treatments.
• Test the paraffin wax on the inside of your wrist to make sure the
temperature is comfortable.
• Do not overfill the unit and always keep the paraffin wax level about
2 inches from the top of the bath.
• Never operate the unit without paraffin wax.
• Do not melt paraffin wax in its plastic packaging, nor melt it over
an open flame, on a range, stove or in a microwave.
• Do not pour the melted paraffin wax from the tub/unit.
• Unplug unit before filling with paraffin wax.
• Do not use accessories or wax not recommended or sold by
HoMedics.
• If the supply cord is damaged, it must be replaced by HoMedics'
Service Center.
• Do not put water into the tub/unit.
Instructions for use:
This unit is controlled by a thermostat. The unit can hold a maximum
of 3.5 lbs. of paraffin wax for operation. The melting time is less than
12 hours and it is designed to run continuously for 24 hours
a day.
Important Note:
This unit may feel very warm to sensitive skin. However, in order to fully
experience the benefits of warm paraffin, the wax must be melted to a
temperature between 123-131 degrees Fahrenheit. For proper
application, quickly dip the body area (i.e. hand or elbow) into the
melted paraffin wax and remove immediately. This should be repeated
6-10 times. Never soak in the wax for more than 1-2 seconds.
If you are very sensitive to heat or feel that this appliance may not be
for you, please return this product to the place of purchase, prior to use.
How to set up the ParaSpa Pro unit:
1. Remove all contents from packaging and check to make sure you
have all of the following components of the ParaSpa Mini paraffin bath:
• Paraffin bath tub
• Plastic lid
• Plastic grate
• Three 1 lb. bags of Paraffin Wax
• 30 plastic liners
4
2. Place unit on a level and sturdy table or surface and remove the lid.
3. Make sure ParaSpa Pro tub is empty before putting wax into tub.
4. Open the bags of Paraffin Wax and place wax in the tub. Open only
as many bags as you plan to use. The unit is designed to hold a
maximum of 3.5 lbs. of paraffin wax and a minimum of 2 lbs. S S e e e e
F F i i g g . . 1 1 Always keep the level of paraffin wax filled to the "MIN" level
marked on the inside of the tub.
F F i i g g u u r r e e 1 1
5. Plug the unit into a 120V A/C household outlet. The green LED light
indicates when the unit is plugged in. The red light will turn on and
off as the heating element works.
N N O O T T E E : : Unit is automatically turned "on" when it is plugged in. If not
used in 48 to 72 hours, turn dial down to "SOLID". If not used for
weeks at a time unplug unit and store in a cool, dry place.
6. Turn the dial to "MELT" to melt the paraffin wax. S S e e e e F F i i g g . . 2 2 The
paraffin wax should melt in less than 12 hours, usually in under 4-5
hours. The red LED light indicates that the heater element is
operating. Place the lid onto the top of the unit.
F F i i g g u u r r e e 2 2
7. Turn the dial to "WARM" after paraffin wax is completely melted.
Remove the lid and place the grate into the wax and allow it to sink
to the bottom of the tub. S S e e e e F F i i g g . . 3 3 Place the lid back onto the top
of the unit. Wait about 1 hour for the paraffin wax to cool down to an
ideal temperature before using. The ParaSpa Pro unit is designed to
be used at room temperature. If the wax starts to solidify or flakes
form on the top surface, turn dial clockwise(right) to increase
the temperature.
N N O O T T E E : : The temperature of the room can have an effect on the
F F i i g g u u r r e e 3 3
unit's performance. Therefore we always recommend testing the
paraffin temperature on the inside of the wrist area before dipping
your entire hand or elbow.
N N O O T T E E : : NEVER dip your hand, foot or elbow into the ParaSpa
bath while the unit is in "MELT" mode!
N N O O T T E E : : Place the grate into the unit only when the paraffin wax
is melted.
How to use the paraffin bath:
F F i i g g u u r r e e 4 4
1. Before immersing your hand or elbow test the paraffin wax on the
inside of your wrist to make sure the temperature of the wax
is comfortable. Remove all jewelry before dipping (i.e. rings,
bracelets, watch).
N N O O T T E E : : It is suggested you wash the area to be treated and apply
lanolin-based hand lotion over the area before dipping it into the
paraffin wax. This will allow the wax to be removed easier and will
help moisturize the skin.
2. Dip your hand or elbow into the melted paraffin wax and remove
F F i i g g u u r r e e 5 5
immediately. Wait a few seconds until the wax solidifies.
Try to avoid moving your hand or elbow while wax is applied.
5
Tabla de contenido
