Operation - Workzone AJ54 Manual Del Usuario

1/4 Sheet Sander · 2.0 AMP

Operation

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
guide including all text under subheadings therein before set up or use of this
product.
WARNING: TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION. Disconnect
the plug from the power source before making any assembly, adjustments, cleaning or
changing accessories.
Always hold the sander off the work piece when turning the switch on or off. Contact the work
piece after the sander has reached its full speed and remove it from the work before turning the
switch off. Operating in this manner will prolong the tool life and will greatly increase the quality
of your work.
Before Use
• Use the dust bag for dust collection
• Note: the use of dust extraction works only with perforated sandpaper.
• Sanding dust is only partially absorbed. Some dust remains on the work piece.
Operating On/Off Switch
Make sure that the switch is in the off position (the "O" position, Fig. 7), then plug in the tool.
TO TURN THE TOOL ON: press the switch to the on position (the "I" position, Fig. 8).
TO TURN THE TOOL OFF: press the switch to the off position (the "O" position, Fig. 7).
Always hold the sander off the work piece when turning the switch on or off. Run the sander
for a few seconds before contacting the work piece and remove it from the work piece before
13
[email protected]
Fig. 7
Operation
Fig. 8
AFTER-SALES SUPPORT
1855 399 9415