Operation - Husky HU80833 Manual Del Operador

 Replace the oil cap / dipstick and securely tighten.
NOTE: This engine has a total lubricant capacity of 20 oz.
(.6 liters).
ADDiNg gASOLiNE TO ThE FUEL TANK
See Figure 16.
wARNiNg:
Gasoline and its vapors are highly flammable and
explosive. To prevent serious personal injury and property
damage, handle gasoline with care. Keep away from
ignition sources, handle outdoors only, do not smoke
while adding fuel, and wipe up spills immediately.
wARNiNg:
Do not allow familiarity with the product to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
wARNiNg:
Always wear safety goggles or safety glasses with side
shields when operating power tools. Failure to do so could
result in objects being thrown into your eyes, resulting in
possible serious injury.
wARNiNg:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
wARNiNg:
Never direct a water stream toward people or pets, or
any electrical device. Failure to heed this warning could
result in serious injury.
APPLiCATiONS
You may use this product for the purposes listed below:
 Using cleaning deck: removing dirt and mold from decks
and cement patios
 Using spray wand: cleaning cars, boats, motorcycles,
outdoor furniture, grills, and house siding
ASSEMBLY
When adding gas to the pressure washer, make sure the unit
is sitting on a flat, level surface. If the engine is hot, let the
pressure washer cool before adding gas. ALWAYS fill the
fuel tank outdoors with the machine turned off.
NOTE: Use unleaded gas only. DO NOT mix lubricant with
gas.
 Before removing the fuel cap, clean the area around it.
Remove the fuel cap.
 Insert a clean funnel into the fuel tank then slowly
pour gasoline into the tank. Fill tank to approximately
1-1/2 in. below the top of the tank neck (this allows for
fuel expansion).
 Replace fuel cap and tighten until the cap "clicks."
 Clean up any spills before starting the engine.

OPERATiON

STARTiNg AND STOPPiNg ThE PRESSURE
wAShER
See Figures 17 - 18.
CAUTiON:
Do not run the pump without the water supply connected
and turned on.
Before starting the engine:
 Connect all hoses.
 Check all fluids (lubricant and gas).
 Turn on the garden hose then squeeze the trigger to
relieve air pressure; hold the trigger until a steady stream
of water appears.
To start the engine:
 Turn the fuel valve to the ON position.
 Put the engine switch in the ON position.
 Pull choke.
 Grasp recoil starter and pull slowly until resistance is felt.
Give recoil starter a short, brisk pull to start the engine.
NOTE: Do not allow the recoil starter to snap back after
starting; return it gently to its original place.
 Let engine run for several seconds, then push choke in.
To stop the engine:
 Put the engine switch in the OFF position.
 Turn the fuel valve to the OFF position.
USiNg ThE SPRAY wAND TRiggER
See Figures 19 - 20.
For greater control and safety, keep both hands on the
trigger handle at all times.
 Pull back and hold the trigger to operate the pressure
washer.
9 — English