Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Intended Use
This appliance is intended for ironing of clothing and textiles.
It is intended for use in households.
Any other use shall be considered as not intended use and can
lead to material damage or even personal injury.
Overview of the Components
1 Handle
2 Steam jet button
3 Temperature control
4 Connecting tube
5 "Temperature" control lamp
6 Iron rest
7 Base
8 Cord clip
9 Releasing device for handle "UNLOCK"
10 Water tank with lime filter
11 Button below the water tank. Releasing device of the water
tank
12 Lime filter cartridge
13 Fill opening
Instructions
Unpacking
•
Remove any protective foils and stickers from the soleplate.
•
Please unwind the lead completely.
Electrical connection
•
Make sure that the iron voltage (see name plate) and the
line voltage match.
•
The mains plug should only be inserted into a correctly
installed socket with earthing contact.
Power Requirements
The station has a total maximum wattage of 2400 W. With this
connected load a separate supply line protected by a 16 A
household circuit breaker is recommended.
CAUTION: Overload!
•
If you use extension leads, these should have a cable
cross-section of at least 1.5 mm².
•
Do not use any multiple sockets, as this device is too
powerful.
Turn on and off
Turn on:
Ensure that the temperature control is in the
"MIN" position. Connect the mains plug to a
properly installed safety socket. The appliance
is immediately switched to operating mode.
Turn off:
Ensure that the temperature control is in the
"MIN" position. Disconnect the mains plug
from the socket.
Function of the Handle (1)
The handle attached to the base serves for carrying the appli-
ance when the mains plug has been pulled from the outlet.
•
To carry the appliance, raise the
handle until it engages (Fig. A).
A "click" confirms that the handle
has been locked. You can use the
handle for transport of the appli-
ance.
•
To release the handle lock, press
the "UNLOCK" button (9) and put
the handle down (Fig. B).
Temperature control on the iron (3)
The symbols on the control correspond to the following settings:
(synthetics, silk)
low temperature
(rayon, wool)
medium temperature
(cotton, linen)
high temperature
•
Turn woolen clothes inside out to avoid shiny spots on the
fabric due to steam ironing. In addition, lay a thin cotton
cloth onto the fabric.
•
Select a low temperature setting for fabrics with additional
surface treatment and iron them inside out.
NOTE:
The iron heats up faster than it cools down. Start ironing with
the lowest temperature setting.
Water Tank (10)
•
The water tank has a recessed grip on the bottom so that it
can be removed. Press the button (11), to pull out the tank.
•
When sliding the tank back into the base, it must audibly
click into place.
•
The fill opening (13) enables you to fill with water even
when the water tank is fitted into the base.
•
The "MAX" mark is located below the fill opening. Do not fill
the tank above this mark. The tank volume is 2.3 litres.
Water
NOTE:
We recommend using the appliance with distilled water only.
Using normal tap water can cause damage to the appliance
once the anti-scale filter cartridge is used up.
Do not fill battery water, water from the clothes dryer and water
containing additives (such as starch, perfume, softener or other
chemicals) into the water reservoir.
This could damage the iron due to residues forming in the
steam chamber. These residues may cause impurities to the
fabric when dropping out of the holes in the soleplate.
37
Tabla de contenido
