Promaker PRO-PC1500KIT Manual Del Usuario página 7

will not get caught on the workpiece,
tools or any other obstructions while
you are working with the power tool.
Make sure any extension cord used
with this tool is in good condition.
When using an extension cord, be
sure to use one of heavy enough
gauge to carry the current the tool will
draw. An undersized cord will cause a
drop in line voltage resulting in loss of
power and overheating.
The table below shows the correct
size to use according to cord length
and nameplate ampere rating. If in
doubt, use the next heavier gauge.
The smaller the gauge number the
heavier the cord.
Be sure your extension cord is
properly wired and in good condition.
Always replace a damaged extension
cord or have it repaired by a qualified
electrician before using it. Protect your
extension cord from sharp objects,
excessive heat and damp or wet
areas.
KEY PARTS DIAGRAM
1. Nozzle
2. Stabilizing stand
3. Air vents
4. Hanging loop
5. Handle
6. Trigger switch
OPERATING INSTRUCTIONS
HEAT GUN APPLICATIONS
The heat gun is a tool that can be
used for many different applications.
As with any power tool, there
are many factors that will affect
its effectiveness and safety. It is
important to be aware of these factors
before you begin to use the tool. The
chart below illustrates examples of
several heat gun applications and
the ideal temperature settings.
Application
Removing adhesive backed
floor coverings
Removing paint
Drying paint or plaster
Heating electrical shrink tube
Heating shrink wrap
"hawing frozen locks
"hawing frozen metal water
pipes
Loosening seized bolts & nuts
Molding and bending plastics
Waxing skis & snowboards
Sealing ends of nylon or
polypropylene rope
Temp.
Setting
Low
High
Low
Low
Low
Low
High
High
Low
Low
Low
7