Case 2: When Pe-Design Next Is Already Installed On The Computer; [Step 1]Upgrading Pe-Design To The Latest Version; [Step 2]Upgrading The Usb Card Writer Module With The Upgrade Wizard - Brother KIT CW Guia De Instalacion

CASE 2: When PE-DESIGN NEXT is already installed on the computer

CASE 2: When PE-
DESIGN NEXT is already
installed on the computer
[Step 1] Upgrading PE-DESIGN
to the Latest Version
Note
• This feature cannot be used if the computer
is not connected to the Internet.
• It may not be possible to check for the
latest version if a firewall is turned on. Turn
off the firewall, and then try performing the
operation again.
• Administrator privileges are required.
• The enclosed CD-ROM2 (for PE-DESIGN)
can also be used to install PE-DESIGN
NEXT version 9.2. Insert the CD-ROM into
the computer's CD-ROM drive, run
"setup.exe", and then follow the installer
instructions.
a
Start Layout & Editing. Click 1, then 2 to
check for most recent software version.
→ The software determines whether or not it is the
latest version. If not, the following message appears.
b
Click "Yes", and then download the latest
version of the software from the Web site.
22
Memo
• If the "Always check for most recent
• If the message shown below appears, the
→ The "User Account Control" dialog box appears.
c
Click "Yes".
[Step 2] Upgrading the USB Card
Writer Module with the Upgrade
1
Wizard
a
Connect the USB card writer module to the
2 computer's USB port, and then start Layout
& Editing.
b
Click 1, then 2 to display the "Options"
dialog box.
→ The following dialog box appears.
version at startup" check box is selected,
the software is checked at startup to
determine whether or not it is the latest
version.
latest version of the software is being used.
1
2