Royal RCHT-1000 Manual De Instrucciones página 6

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
LED display with temperature:
1. buttons for setting the temperature
2. Set button
Functioning
The temperature in the cabin is measured in regular intervals. This information is
transmitted to the thermostat as a current value, and gets compared to the value set
by the user.
If the current value is lower than the set value, the thermostat makes the device
heat.
If the current value is higher than or equal to the set value, the thermostat stops
heating.
Regardless of this cycle, the digital display shows the ambient temperature in the
cabin, so that the user can compare it to the set value and adjust it more precisely in
an easy way.
OPERATION
1.
Plug in the device and turn it on using the ON/OFF switch, the display will turn
on.
2.
Regulate the thermostat on the chosen value:
a) First press the „Set" button on temperature display one time.
b) Press the "˄" or "˅" button to select your required temperature. After 1 to
3 seconds the display will revert back to actual temperature.
c) The orange light will come on when the element is heating. This will switch on
and off automatically during the heating process.
3.
The control light turns on, the heating element starts to heat and the tempera-
ture in the cabin raises little by little.
4.
You can then insert the water tray into the showcase (with about 0.6 litres of
water). The evaporating water prevents the meals from drying out due to heat
developed inside the device.
5.
As soon as the set temperature is reached, the control light turns off and the
heating element stops to heat.
10
6.
As soon as the temperature in the cabin decreases, the thermostat reacts to it:
the control light turns on again and the heating bar restarts to heat.
7.
After use, turn off the device using the main switch.
8.
Generally speaking, it is advisable to unplug the device while not used.
9.
When the device cooled down, take out the water tray, empty and clean it. This
should be done after each use to keep the device in perfect hygienic condition.
10. To clean the rest of the device, watch out to protect the electric parts from hu-
midity and from direct water contact to avoid electric shocks and shortcircuits.
An impregnated cloth is easily sufficient if you regularly clean the device.
11. If you don´t use the device for a longer time or stock it, check the humidity and
temperature conditions: the air has to be dry and the device should be covered
to be protected from dust deposits.
REGULAR CONTROL OF THE DEVICE
Control regularly that the device doesn´t present any damage. If it should be the case,
please contact your customer service to solve the problem.
What to do in case of a problem?
Please contact your customer service and prepare following information:
Invoice number and serial number (the latest is to be found on the technical
plate on the device)
If relevant, a picture of the damaged, broken or defective part
It will be easier for your customer service clerk to determine the source of the
problem if you make a detailed and precise description of the matter.
Avoid formulations like "the device doesn´t heat", which may mean that it
doesn´t heat enough or even not at all. Though, those two possibilities have a
different causation!
Indicate the performance of the lights to facilitate the diagnosis.
Check with a thermometer that the device measures the temperature within
the cabin properly. (Caution: do not set the thermostat on a value exceeding the
maximal value of your thermometer!)
The more detailed your information, the quicker and more efficient the customer
service will be able to take care of your problem!
CAUTION: Never open the device without the authorization of your customer ser-
vice. This can lead to a loss of warranty!!
Rev. 14.03.2017
Rev. 14.03.2017
11
Tabla de contenido
loading

Tabla de contenido