worn or damaged hoses can result
in injection injuries. DO NOT TREAT
FLUID INJECTION AS A SIMPLE
CUT! See a physician immediately!
WARNING:
Asphyxiation and burn. Never fill fuel
tank when engine is running or hot.
Do not smoke when filling fuel tank.
•
Never fill fuel tank completely.
Fill tank to 1/2" )12.7 mm) below
bottom of filler neck to provide
space for fuel expansion. Wipe
any fuel spillage from engine and
equipment before starting engine.
•
Never run engine in doors or in
en closed, poorly ven ti lat ed areas.
En gine exhaust con tains carbon
mon ox ide, an odorless and deadly
gas.
•
DO NOT let hoses come in contact
with very hot engine muffler during
or immediately after use of your
pressure washer. Damage to hoses
from contact with hot engine
surfaces will NOT be covered by
warranty.
NOTICE: Risk of property damage.
Never pull water supply hose to move
pres sure washer. This could damage
hose and/or pump inlet.
•
DO NOT use hot water, use cold
water only.
•
Never turn water supply off while
pressure washer engine is running
or damage to pump will result.
•
DO NOT stop spraying water for
more than two minutes at a time.
Pump operates in bypass mode
when spray gun trigger is not
pressed. If pump is left in bypass
mode for more than two minutes
internal components of the pump
can be damaged.
If you do not understand these
precautions,
please
customer service department at www.
power-washer.us or 1-800-381-0999!
Risk
of
fire,
contact
our
Prior to starting, refer to your engine
manual for proper starting procedure.
1.
In a well ventilated outdoor area
add fresh, high quality, unleaded
gasoline with a pump octane rating
of 86 or higher. Do not overfill. Wipe
up spilled fuel before starting the
engine. Refer to Engine Owners
Manual for correct procedure.
2.
Check
Engine Owners Manual for correct
procedure.
3.
Connect the water hose to the
water source. Turn the water
source on to remove all air from
the hose. When a steady stream
of water is present, turn the water
source off.
4.
Verify
is
in
NOTE: Cone side faces out.
10
5.
Connect high pressure hose (C) to
pump outlet (I).
11
6.
Connect water source (N) to pump
inlet (J). NOTE: Water source must
provide a minimum of 5 gallons per
minute at 20 psi.
12
14- ENG
engine
oil
level.
the
filter
screen
water
inlet
of
M
I
C
j
N
See
(M)
pump.