Important Safety Notes - REMS Basic E 01 Instrucciones De Servicio

eng
See the REMS radial presses operating instructions!
Important safety notes:
DANGER DANGER
Danger with a high degree of risk which results in death or severe injury (irreversible) if not heeded.
The T 12 pressing inserts (Art. No. 570891) are intended for use in the REMS Basic E 01 pressing tongs (Art. No. 571855).
To avoid danger to life and limb, the mentioned pressing inserts/pressing tongs may only be used for fall protection systems if
they have been tested and approved as suitable by the fall protection system provider. All other uses are not for the intended
purpose and are therefore prohibited.
The REMS products listed in the table were tested and approved as suitable for the specified fall protection systems by the
named system manufacturers/providers when driven by the named REMS radial presses.
Also read and observe all the safety notes and instructions of the system provider. Check every pressing with a gap gauge
belonging to the system. If this cannot be pushed over the pressed square, the pressing is not system-compatible and may not
be used. In this case the pressing inserts must be changed.
Do not use the REMS Basic E 01 pressing tongs and T 12 pressing inserts if they are damaged.
5