Tabla de contenido
Technical Manual & Parts Lists
Motor Parameter Settings
Before Programming, Perform a Master Reset of Parameters (See Below)
PARAMETER
RANGE
290
026
111
119
153
161
207
220
240
270
272
020-255
436
401
Front panel LED's:
LED 1: Off
LED 2: Off
LED 3: Off
LED 4: Off
LED 5: Off
LED 6: Off
LED 7: Off, Stop at needle down.
LED 8: Off
Speed
Fast
Slow
17
(3300A-PrePAR)
VALUE
0
0
0-999
0900
1-3
1
0-50
0
0-1
1-CCW
1-55
1
1-55
1
0-56
55
0-5
5
1000
0
1
RPM
Treadle/Low
163
C
135
A, C
DESCRIPTION
Mode of operation. MUST SET THIS PARAMETER
FIRST!
Maximum speed when "129" is 0, 1, or 2.
Linear acceleration
Braking power at standstill
Motor rotation
Braking
Acceleration
Enable reverse run of motor with input 1
No handwheel sensor
Drive ratio between motor pulley and handwheel pulley. If
handwheel pulley is smaller than motor pulley, increase
this value to slow down sewing head until measured
speed matches speed set with parameter 111.
Programming Instructions:
1. Power on holding down the "P" button till "CODE" is
displayed.
2. Press ">>" once and enter the number "5913"
3. Press "E" once and "4.0.0." is displayed this is a
parameter
4. Proceed to the parameter to be changed and press
"E"
5. The value now shows in the screen, adjust to desired
value.
6. Press "E" to enter value and continue with parameter
setting.
7. Repeat for other parameters, press "P" once when
complete.
8. Run sewing head to save parameters before powering
down
To Perform Master Reset of Parameters:
1. Power on holding down the "P" button till "CODE" is
displayed.
2. Press ">>" once and enter the number "5913"
3. Press "E" twice and "093" is displayed.
4. Press "+" once, "094" is displayed.
5. Press "P" to exit programming mode with all default
values.
Tabla de contenido
