Troubleshooting - HQ-Power VDSCD3000 Manual Del Usuario

• COAST EFFECT
This effect simulates turning off the power to a turntable, which will cause a turntable platter to slowly spin
down until it looses momentum and stops. The coast effect may also be used to simulate a turntable slowly
going up to its proper speed. Press the coast button to activate.
• COAST EFFECT PARAMETERS
The parameters can be adjusted from 0ms to 9.9s. To adjust the effect parameters, press the coast button and
use the jog wheel to adjust. All parameters will return to their default setting once the unit has been powered
down.
• FILTER EFFECT
The filter is a type of dampening effect that tweaks with the harmonics of a track. This effect uses a low-pass
and high-pass filter to distort the audio track. The effect works with both (low and high) simultaneously. To
activate, press the filter 1 button.
• FILTER OPERATION
Filter 1 effect can be created in 2 ways once filter 1 has been engaged.
o Use the pitch slider to change the type of filter being applied. The filter 1 parameters range from -127 to
+127. The filter will automatically return to the default setting when you stop moving the pitch slider.
o Use the jog wheel to adjust the parameters.
• FILTER AUTO SCAN FUNCTION
To lock the filter in a loop, press the filter 2 button. This function will lock the filter effect in a continuous effect
until filter 2 button is disengaged.
• FILTER TIME PARAMETER
Filter 2 has an adjustable time parameter from 20ms to 9.9s. This is the amount of time it takes the filter to
cycle through the low-pass filter. This parameter can be adjusted at any time.
• FILTER PARAMETER HOLD
To lock the filter at a specific parameter, press the hold button. This will engage the hold function which will
lock your desired filter parameter and set a new default value. Your default value will be erased once the unit
is powered off.
• PITCH BEND HOLD
To lock the pitch at a specific parameter, press the hold button. This will engaged the hold function which will
lock your desired pitch bend parameter and set a new default value. Your default value will return to the
original pitch once when you move the pitch slider.

8. Troubleshooting

Problem Cause
No power - The power cord isn't connected.
- The fuse is melting.
No sound - Audio cable isn't well connected.
- Incorrect source selection.
- Incorrect audio setup.
Unable to play - No disc loaded.
- Defective disc.
- Disc is loaded upside down.
- Dirty disc.
- Parental control activated.
Key malfunction - Power wave or other static interference.
VDSCD3000
Solution
- Connect the power cord properly.
- Replace the fuse with a fuse of the same type
and rating
- Connect the cable properly.
- Switch to the proper source.
- Select the suitable audio setup.
- Load a disc.
- Replace the disc.
- Load the disc properly.
- Clean the disc.
- Deactivate the parental control or change
setup.
- Switch off the player, switch on again.
11 HQ POWER