Tabla de contenido
M4x8
(4x)
4
3
182
iii-1
iii-2
1
2
5
iii-3
Installation
iii Installation procedures
Wheel balancer:
Refer to the drawing for correct wheel balancer
positioning. If the wheel balancer needs securing,
we recommend fixing elements with a diameter of
8 mm, quality 8.8 or higher.
Supports for Accessories:
• Unpack the 4 threaded accessory support studs
and the support plates.
• Refer to Figure iii-1. Fit the 4 threaded accessory
support studs and the plates.
Clamping devices:
• Put the clamping devices on the accessory studs.
Fitting and connecting the monitor
Fig. iii-2 VESA support
The 4 screws needed (M4x8) to fix the VESA support
to the monitor are part of the kit supplied.
Fix the VESA support to the monitor.
Figure iii-3 Connection of monitor and PC
Caution
Before connecting the electronic cables turn off the
mains switch.
Plug in the plug (1, Fig.iii-3) of the power supply
cable.
Insert the monitor connector into the right socket
(2) of the embedded unit.
Insert the connector USB (3) into the PC and the
monitor.
Insert the monitor main connector (4) into the
socket.
Insert the audio Jack (5) in the monitor socket.
Note:
The warning beeps from the machine
cannot be heard if the audio cable is not
connected.
iv Test procedures
• Balance a wheel to less than 0.25 oz. (5 grams) per
plane.
• Perform a User Calibration.
v Instructing the operator
(Following applies only if a unit is installed by a service
Technician)
• Show and explain the Safety Booklet.
• Show the operator how to switch the unit on and off.
• Show the operator how to perform an emergency stop.
• Show the operator how to select a wheel type, enter
data and apply a weight.
6.2.
Tabla de contenido
