Control Panel - IPC SG-48 S8010 M Manual De Instrucciones

CONTROL PANEL

9
8
4
9a
• 1 General switch
• 2 Display
• 3 Detergent switch
• 4 Steam adjustment knob
• 5 Connector block for hose
• 6 Pressure gauge
• 7 Water tank cap
• 8 Detergent tank cap
• 9 Vacuum switch
• 9a Dirtwater bucket
PREPARATION and START TO USE
Open the cap (7) and fill the tank with tap water.
-Note: If the water
"very hard"(>20°F), It is recommended the use of 50%
demineralized water or distilled water, (this to avoid
excessive limestone formations and to be sufficiently
conductive)
ATTENTION: Do not add detergents, anti-limestone
solutions or essential oils in the water tank boiler (7),
these can cause irreparable damage to the boiler and
circuits.
-Fill the detergent tank (8) with a no-foam detergent.
-Hook the dirtwater bucket (9a)
-Connect the plug to a socket on an electrical
interconnection conformed to the rules of the country,
equipped with a switch and an earth terminal efficient.
START TO USE:
Turn the main switch on (1). The pump will charge the
boiler before starting to heat.
The display (2) will turn on and indicate for a couple of
seconds the revision index of the PCB, the liter of water
consumed and will proceed with the temperature-
pressure status (HEAT) of the machine, when the
machine is ready, it will visualize "176C". (usually the
machine needs around 6 minutes to be ready.)
Choose the most suitable accessory for the needed use
and connected it to the multifunction handle (14), by
means of the extension tubes, then insert the hose
connector to the block (5), push until you hear a click.
7
2
1
6
5
3
available should be
12
11
13
14
• 10 Steam delivery lever
• 11 Vacuum switch
• 12 Detergent switch
• 13 Steam lever (10) lock button
•
14 Tubes/accessories attachment
When the machine is ready, to release steam through
the handle of the flexible, press the lever button (10).
Now use the brush or accessory in the surfaces to be
cleaned.
Attention: it is recommended to perform the first
release of steam after the heating on a container for
about a minute, this is to collect any condensate water
generated in the initially cold ducts.
Attention: if you are working on delicate
surfaces or things, keep the steam jet at an
adequate distance of at least 20-40cm.
DETERGENT USE:
If you need to use detergent check and fill the tank
(8), turn the function on by pushing the button (3) on
the front panel (CHEM), keep it pushed to regulate the
ejection level by seeing it changing on the display, to
save the value, release and press again to confirm.
Now push button (12) on the handle in order to start
releasing detergent on the surface to be cleaned. To
stop it, push again button (3) (C.Off).
VACUUM USE:
Before vacuuming, take the bucket (9a) off and check
that the filter is in place. Control if the switch (9) it
turned on. Now press button (11) and you can
vacuum dirt and liquid (in the display you will see
"MAH" showing the activation of max. vacuum). When
the bucket (9a) is full with dirty water, the vacuum
noise changes and then stops; stop the machine
immediately and empty the bucket. When vacuuming
operations are done, it is advise to clean the filter and
dry the bucket or let it open so that it can dry itself.
13
10