Idiomas disponibles
Idiomas disponibles
accidents. This unit does not have to
be used in any case like toy.
4
The owner is responsible for
ensuring that anyone who uses the
machine is duly informed about the
necessary precautions.
5
Your unit can only be used by one
person at a time.
6
Use suitable clothing and footwear.
tie up your shoelace correctly
1.-
ASSEMBLY INSTRUCTIONS.-
Take out all of the assembly pieces
and remove the packing. Check that
all of the assembly pieces are present,
Fig.1.
ATTENTION: The assistance of a
second person is recommended
when assembling this machine.
Fig.1 Parts list:
(1) Console.
(3) Console cover.
(14) Main frame.
(27) Sensor wire.
(46) Pedals.
(77) Seat.
(118) Right focus bar.
(119) Left focus bar.
(120) Post.
(121) Front stabilizer.
(122) Rear stabilizer.
Fasteneers List:
(2) Screw M5x10.
(4) Screw M4x14L.
(5) Screw M10.
(6) Nut M10.
(7) Bushing.
(8) Screw M8.
(9) Flat washer.
Wrenches.
2. FITTING THE STABILIZER.-
ATTENTION: The assistance of a
second person is required for this
stage of the assembly.
Remove
stabilizers.
Take the rear stabiliser (122) with
adjustable feet and position it on the
machine's rear stand, insert the bolts
(8) with the washers (9) and nuts (6),
tighten securely. Fig.2.
Go
through
procedure with the front stabilizer
(121).
3. ATTACHING THE PEDALS.-
The assembly instructions for the
pedals must be followed to the letter,
fitting these incorrectly could damage
the screw thread on the pedal or the
crank. Right and left refer to the
position that the user adopts when
sitting on the saddle to do the
exercises.
The right-hand pedal (46R), marked
with the letter (R), screws onto the
right-hand crank, also marked with an
(R), in a clockwise direction. Tighten
securely, Fig.3.
The left-hand pedal (46L), marked
with the letter (L), screws onto the left-
hand crank, also marked with an (L),
in an anti-clockwise direction. Tighten
securely Fig. 3.
4.- FITTING THE MONITOR.-
Take hold of the monitor (1) and bring
it up to main frame (14), connect the
terminal, coming out of the bottom of
the monitor, with terminal (27) coming
up out of the top of the main body
(14), Fig.4.
12
protections
the
same
assembly
from
