Cleaning And Maintenance; Technical Data - HSM shredstar X15 Instrucciones De Servicio

6 Cleaning and maintenance

Switch off the shredder and pull out the mains
plug. When cleaning only use a soft cloth and
a mild soap-water solution. However, no water
may enter the equipment.
Oil the cutting unit when
cutting performance deterio-
rates or the device becomes
noisy, or every time you
empty the waste container.
• Squirt special cutting unit oil through the
paper feed across the entire width of the
cutting shafts.
• Without feeding in paper, run the cutting unit
in reverse (REV).
 This loosens paper dust and particles.

8 Technical data

Cutting type *
Shred size *
Sa fe ty ra ting German DIN 66399
Cutting ca pa ci ty
Lo ading width *
Cutting speed *
Voltage
Power
Dimensions W x D x H (mm)
Weight
Volume of shred. mat. container *
Noise level (Idle running/ load)
*
: only applies to the paper cutting unit
10/2013
7 Disposal / Recycling
Electrical and electronic old devices
contain a variety of valuable materi-
als, but also hazardous substances
which were required for function and
safety. Incorrect disposal or handling
can be dangerous to your health and
the environment. Never dispose of old devices
in the household waste. Observe the current
applicable regulations and use the collection
points for returning and recycling electric and
electronic devices. Dispose of all the packaging
materials also in an environmentally-responsi-
ble way.
P-4 / O-1 / T-2 / E-2 / F-1
15 sheets of paper (80 g/m²) or 1 CD (max. 1.2 mm thick)
or 1 credit card / store card
230 V / 50 Hz
380 x 320 x 580
58 dB(A) / 65 dB(A)
shredstar X15
english
Cross cut
4 x 35 mm
228 mm
34 mm/s
300 W
16 kg
27 l
13