Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 44
PROBLEM
The motor will not start.
The motor switches off after a
short time.
The motor does not reach max
rpm
The cutting tool does not turn:
immediately switch the tool
off!!
Abnormal vibrations:
immediately switch the tool off!
The cutting tool and the motor
will not switch off: immediately
remove the battery!!
LED FLASHES
Red
Green
Yellow
Red / Green / Yellow

8. TROUBLESHOOTING

CAUSE
The battery is not connected.
Switch on zero.
Battery problem (low voltage).
The power cord is cut.
Circuit board damaged.
The recharging level of the battery is low.
Overheating.
The battery has not been properly
connected.
The battery is dying.
Circuit board damaged.
The tightening nut of the cutting blade is
loose.
The transmission rod has not been
inserted properly.
Circuit board damaged.
One of the two nylon wires is broken and
the head is no longer balanced.
The cutting blade is bent, cracked.
The tightening nut of the cutting blade is
loose.
The cutting blade is not properly fastened.
Circuit board damaged.
STATUS
Battery dead.
Motor stalled, overloaded.
Motor or Controller over temperature.
Accelerator calibration request.
Connect the battery.
Recharge battery. If recharging is not efficient, replace
Contact an authorised ACTIVE service centre.
Recharge battery. If recharging is not efficient, replace
Switch off the tool and wait for it to cool down.
Disconnect and re-connect the battery properly.
Recharge battery. If recharging is not efficient, replace
Contact an authorised ACTIVE service centre.
Properly tighten the nut following manual instructions.
Check transmission connections.
Contact an authorised ACTIVE service centre.
Hit the nylon cutting head on the ground to cause the wire
Replace the cutting blade.
Properly tighten the nut following manual instructions.
Contact an authorised ACTIVE service centre.
The device is blocked, release the accelerator.
Wait for the machine to cool down.
Visit an ACTIVE service centre.
21
GB
ENGLISH
SOLUTION
Turn switch to 1.
battery.
battery.
battery.
to come out.
WHAT TO DO
Recharge battery.
Tabla de contenido

Solución de problemas

loading

Tabla de contenido