Allett Liberty Classic 30 cm Instrucciones De Funcionamiento página 17

F016J11384-A
Cylinder and Blade sharpening
The cylinder and bottom blade can be re-sharpened. This is recommended every 2-3 years
or as required. Blunt or dull blades will adversely affect cutting performance and battery life.
Please contact your local dealer for information. You can search for your nearest registered
dealer on-line at www.allett.co.uk/allett-dealer-locator
Cleaning & Storage
Clean the mower, battery and charger with a soft dry brush or cloth, paying particular
attention to the cooling fins on the end of the motor and charger. If the grass box or
interchangeable cutting cartridge are removed from the lawnmower they may be cleaned
with water from a hose. Lubricate the cutting cylinder with a light oil to displace any water
after cleaning and when storing at the end of the season.
Remove the battery and isolation key, store both machine, battery and charger in a safe,
cool and dry place, avoiding areas of high humidity.
At the end of the season do not store the battery in the mower. Keep it in shady, cool and dry
conditions.
Removing/replacing a Qc Cylinder Cartridge
Please refer to illustration (O) and (P) for Liberty 30 & 35
The mower is fitted with a Qc (Quick change) cartridge which can be removed and taken to
an Approved Service Agent for sharpening. To remove the cartridge:
Remove the grass box (D).
Remove grass box cradle (D).
Remove the drive cover (28) by removing screws (29).
Remove cartridge retaining screws (24) on both sides.
Remove pulley (32) and belt (26) by removing 3 screws (27).
Pull the cutting cartridge unit (25) out using the handle. Obtain assistance if required.
Replace the cartridge and fit retaining screws (24).
Slacken the idler pulley screw (34).
Refit the pulley (32) and belt (26).
Adjust the idler pulley (33) against the belt (26) and tighten idler pulley screw (34).
Refit the drive cover (28).
This method is the same for fitting or removing
Please refer to illustration (Q) for Liberty 43
The mower is fitted with a Qc (Quick change) cartridge which can be removed and taken to
an Approved Service Agent for sharpening. To remove the cartridge:
– Remove the grass box (E).
– Remove grass box cradle (E).
– Remove the drive cover (28) by removing screws (29).
– Remove cartridge retaining screws (24) on both sides.
– Pull the cutting cartridge unit (25) out using the handle. Obtain assistance if required.
– Refit cartridge (25) following the above in reverse. This method is the same for fitting or
removing cartridge accessories.
Mowing
For best results, place the lawnmower on the edge of the lawn, mow in a forward direction. Then turn around and mow parallel to the previously cut strip, slightly overlapping the
previous run.
17
Original instructions